Xantrex Technology XDI2048 manual User Interface, User Lines, Front Panel LED Functions

Inverter Module Installation and Operation

User Interface

Front Panel

Table 3-1	Front Panel LED Functions
Red LED	Green LED	Function
ON	OFF	A continuously incompatible operating condition
		exists and an alarm has tripped. See “Protections
		and Alarms” on page 3–7). The inverter is
		automatically turned off until the fault/alarm has
		been cleared.
OFF	ON	Regular operating conditions. Output is on and
		delivering power.
OFF	fast flashing	Self-Diagnostic mode. Prior to enabling the
		inverter the unit always performs a self-check and
		diagnostics.
OFF	slow-short flash	Stand-by mode.

User Lines

The port with user lines is located at the rear panel of the rack mount frame (Figure 2-3). See Figure 2-7. The following table lists the signals:

Table 3-2User Line Pins

Pin	Name	Function
1	User_Ground	All user lines are referenced to user_gnd. User_gnd is
		isolated from both the input DC power and the output AC
		power.
2	Shut_Down	This is an input pin. The input impedance is 100 Ω in
		parallel with 20 pF. A logic high (1.25 V to 5 V) would set
		the inverter into Standby Mode (see page 3–5). If pin 2 is
		floating, the internal pull_down resistor of 100 Ω will
		force a logic “0” and this pin becomes inactive.
3	Fault_Flag	This is an output pin. A logic high (5 V) indicates that an
		alarm has tripped. The output of the inverter is, therefore,
		disabled.

4Auxiliary_Line This is an output pin. The functionality of this user line is factory preset. It can be user configured if the Ethernet option is installed.

	5 Inverter_On	This is an output pin. A logic high (5 V) indicates that the
		inverter is in an “on” state and delivering AC power to the
		AC output power terminal.
3-6		TM-DIOP-01XN-01