Xantrex Technology XMP 2600 manual Commands and Queries Reference

Table of Contents
Output on/off	30
Other operations	30
Sequential Operations	30
Using hardware (TRIG and SYNC) to serialize operations	30
Using software (OPC mechanism) to serialize operations	31
Controller notification of Operation Complete	31
Selective shutdown	32
Shutdown grouping: single, group, global	32
The different shutdown grouping of modules	32
The commands to program shutdown grouping	32
Shutdown on non-fault events	33
Comm. time out	33
Responding to communication time out events	33
Turn-on and reset behavior	34
Time out events as reflected in the status structure	34
Chapter 5: Commands and Queries Reference	35
Categories	35
IEEE 488.1 BUS Commands	35
System Commands and Queries	35
Settings Commands and Queries	37
Output Control Commands and Queries	37
Protection Commands and Queries	37
Warnings Commands and Queries	38
Read-Back Queries	38
Trigger and Sync Commands and Queries	38
Status Reporting Commands and Queries	39
Synch. Commands and Queries	39
Alphabetical reference	40
Chapter 6: Status reporting	69
IEEE 488.2 compatible Status Structures	69
Power Modules Status Structure	69
The Events Register	69
The Warnings Register	69
The Output Register	70
The Faults Register	70
The Status Register	70
The Error Code	70
The Events Enable Register	70
The Events Filtering Positive Mask Register	71
The Events Filtering Negative Mask Register	71
Power Modules Summary Register - read with SRQS?	72
XMP 2600 System Status Structure	72
Standard Event Status Register - read with *ESR?	72
Standard Event Status Enable Register - set with *ESE read with *ESE?	73
Primary Status Register - read with PSR?	73
Primary Event Status Register - read with PER?	73

XMP 2600 Programming Manual rev. 1.1 k