Summit HL-630 OPC manual HP LaserJet M3027/3035/P3005, HP LaserJet M5035, HP LaserJet P2015

HP LaserJet 9000

HP Part # C4583X

OEM Stated Yield: 30,000

Like the HP-4100, the 9000 cartridge also uses a chip. The chip in the 9000 is the same as the 4100 in that they only monitor usage not page counts. Each chip also has its own serial number which in effect gives the cartridge a serial number. After the OEM toner has been used up, the “toner low reached” code will be set to YES on the cartridge chip. Even after the cartridge is refilled, the printer display will still show “Toner Low” for the supplies status section of the menu. The main display will then show “Non HP Toner cartridge”. If the chip is removed, the toner low sensors will be disabled, and will not work again until a new HP cartridge is installed. New replacement chips are available.

HP LaserJet M3027/3035/P3005

HP Part # Q7551A, Q7551X

OEM Stated Yield: 6,500 Q7551A, 13,000

Q7551X

The Q7551A/X cartridges use the older 2nd generation of chips. They are identical in looks to the 4200/4300 series. As these machines had just been released at the time of this writing, no information on the chip function is available. Check with your supplier for more information.

HP LaserJet M5035

HP Part # Q7570A

OEM Stated Yield: 15,000

The M5035 uses the latest or 3rd generation chip. They are very small, and the code is all new. They are identical in looks to the 5200 series. As these machines had just been released at the time of this writing, no information on the chip function or reset if needed is available. Check with your supplier for more information.

HP LaserJet P2015

HP Part # Q7553X

OEM Stated Yield: 15,000

The Q7553X cartridges use the older 2nd generation of chips. They are identical in looks to the 4200/4300 series. The code is all new but as these machines had just been released at the time of this writing, no information on the chip function or reset if needed is available. Check with your supplier for more information.

Kyocera F-1000 OPC

Kyocera OPC Part # DK-3

OEM Stated Yield: 10,000

There is a small black fuse located on the board inside the cartridge. This fuse must be replaced each cycle by un-soldering the old and soldering in the new. This fuse is a special 250mA one that should be purchased from your supplier. The same fuse is used in the F-3010 OPC Cartridge.

15