Xerox DC, Xerox N-24/32/40 | Summit HL-630 OPC specification

type of replacement cartridge that the machine is expecting. 001=113R180/181, 005 = 113R287.

If the cartridges your machine needs is not available, you can change what type of cartridge the machine will accept by doing the following. Enter the diagnostics mode as in above. Enter “406 “ and press Print. Turn off the power and install the correct cartridge. The machine will now look for that type of cartridge from now on. Only do this if you are sure that you will be supplying the cartridges for this machine. If the customer goes out and purchases the “correct” cartridge that was made for his machine, it will no longer work until the above procedure is run again.

Xerox DC 220

Xerox Cartridge part #

113R120/113R178/113R276 OEM Stated Yield: 20,000

To reset the counter in the DC 220/230/240 OPC cartridges the connector on the rear of the cartridge must be replaced. This will clear the J1 or J7 codes. J1= Toner Out, J7 = Change cartridge

There are many different cartridges that use different connectors/chips for these machines. A list of them is as follows:

DC220/230/420 Type A: 113R120, 113R178,

113R276DC220/230/420 Type B: 113R179, 113R275

DC220/230/420 Type C: 113R313

DC332/340 Type A: 113R315, 113R317

DC332/340 Type B: 113R316

Each cartridge type is for a different machine. When ordering the replacement chip, make sure you know the correct cartridge part number that your customer’s machine calls for. The chips are not interchangeable.

Other cartridges error codes are:

J6: Incorrect cartridge type

J3: Cartridge not seated properly, or not present

Xerox N-24/32/40

OEM Stated Yield: 20-23,000 (Depending on

cartridge)

This engine has more non-interchangeable cartridges than any engine I have ever seen. All of them use an "ARD" that is built into the connector. Almost every type of cartridge has it's own individual ARD. Since every individual cartridge has it’s own chip, it is imperative that you have the OEM cartridge part number when ordering the chips! The reset boards are now available with the plastic housing so that soldering the chip in is no longer necessary. There are also services where you can have the old chip reset. There are still cartridges that do not have replacement chips available yet. These are mainly international, but not all.

Xerox P8E (Samsung FS-5000

Engine)

OEM Stated Yield: 5,000 (Except for Lexmark

13T0101: 6,000)

There are 3 main versions of this cartridge so far. The Xerox Docuprint P8e 113R296/100R364, WorkCentre 385 113R 296, and the Lexmark Optra E310/312 NOTE: Lexmark has replaced the 12A2202 (5k) cartridge with the 13T0101 (6k) cartridge. The new cartridge works in both machines.

When recycling these cartridges the fuse must be replaced in the Xerox cartridges. The Lexmark cartridges have a plastic dummy fuse in it. There has been some conflicting information on if the fuse should be replaced or not, the following should help to clear it up. If the machine says toner low and the