Summit HL-630 OPC manual Okidata OP-14e, OkiFax 5700/5900, Okidata OP-20/24 OPC

Okidata OP-14e

Okidata OPC Cartridge Part #41331601 (Type 8)

OEM Stated Yield: 20,000

(The procedure for these machines is the same as used for the Okidata OP-6e, OL-600e, OP-10e)

From the computer the printer is directly hooked up to, enter the Printer Status Monitor. Click on the “Printer Menu” tab. Click on the “Maintenance” tab. Click on the “Drum Counter Reset” tab.

OkiFax 5700/5900

Okidata OPC Cartridge Part # 40433308

20,000

Press the “Menu/Exit” key. Press the “Down Arrow” until the display shows “Counter”.

Press “Enter” twice. Press “Clear” twice. Press the “Menu/Exit” key. The counter is reset!

Okidata OP-20/24 OPC

Okidata OPC Cartridge Part # 40468701

OEM Stated Yield: 30,000

(The procedure for these machines is the same as used for the Okidata OL-400e, OP-20, & OP-24)

Turn off the printer. While holding the MENU1/MENU2 button down, turn the printer back on. Keep holding the button down until you see USER MNT on the display panel. Release the button.

Press the MENU1/MENU2 button three times. The display will read DRUM CTR RESET.

Press the ENTER button. The display will read WARMING UP, and finally ON LINE. The counter is reset!

Panasonic KXP-4400 OPC Cartridge

Panasonic OPC Cartridge part # KX-PDM6

OEM Stated Yield: 6,000

This cartridge uses an optical reset. The waste chamber must be spotless!! There is a float inside that moves up as the waste toner increases. There is a small clear piece of plastic on the waste chamber with a black plastic float inside. This must be spotless and the float should be at the base. If this piece is dusty, or the float is up the printer will not reset.

Panasonic KXP-4410 OPC Cartridge

Panasonic OPC Cartridge part # KXPDM4/5

OEM Stated Yield: 12,000

This cartridge uses an optical reset. The waste chamber must be spotless!! There is a float inside that moves up as the waste toner increases. If you remove the small circuit board on the side you will see a small clear piece of plastic. This must be spotless and the float should be at the base. If this piece is dusty, or the float is up the printer will not reset.

28