Summit HL-630 OPC manual Lexmark E220, Lexmark E23x/24x/33x/34x

E-120 Drum cartridge: With the printer turned on, open the front door. Press and hold the CANCEL button until all the lights begin to cycle. Close the front door. Press the continue button to resume printing.

Lexmark E220

Lexmark Cartridge Part 12S0300 (Return Program),

12S0400 (Standard)

OEM Stated Yield: 2,500

This system uses a separate toner and drum cartridge. The “Return program” toner cartridge has a “Killer Chip” on it that must be replaced each cycle. On the Standard cartridges the chip is also present, but the killer part is not active. These cartridges can be re-manufactured as much as you want, the chip will not interfere.

Lexmark E23x/24x/33x/34x

Lexmark OLD Toner Cartridge Part #’s 12A8400,

12A8405 (Return Program), 12A8300, 12A8305 (Standard)

OEM Toner Stated Yield: 2,500 (8400,8300)

6,000 (8405, 8305)

Lexmark NEW Toner Cartridge Part #’s 24015SA,

34015HA (Return Program), 24035SA, 24035HA (Standard)

OEM Toner Stated Yield: 2,500 (240 cartridges)

6,000 (340 cartridges)

OEM Drum cartridge 12A8302, Stated drum yield:

30,000

Toner cartridges: The “Return” toner cartridges have an ARD on a small board located inside the right end cap of the cartridge. Like other cartridges in this series, the board for these cartridges has two contact pads where the machine makes direct contact. New replacement chips are available now. On the Non-Prebate cartridges the chip is also present, but the killer part is not active. The Standard cartridges can be re-manufactured as much as you want, the chip will not interfere. In both cases, the chips use the new “Overdrive code”. Make sure your supplier is up to date with the proper code. There are multiple other printer brands that use this engine. Some manufacturers have universal chips, some have individual chips. Make sure you have the correct ones.

E23x, e33x, and E240 Drum units: With the printer turned on and in the READY state, open the front cover. Press and hold the CANCEL button until all the lights begin flashing up and down. Release the CANCEL button and close the door.

E340, E342 Drum units: Turn the printer off. With the printer still off, press and hold the SELECT and RETURN buttons. While still holding the buttons down, turn the printer back on. Keep holding them down until the screen shows PERFORMING SELF TEST or CONFIG MENU. Release the buttons when either of these messages are displayed. Press the left or right arrow buttons until RESET PC CNT appears on the display. Press the SELECT button. When the display shows CONFIG MENU again, turn the printer off. Wait 5 seconds and turn the printer back on. (Do not hold any buttons down this time). The counter is reset!

DELL 1700/1710 Drum units: With the printer on, press and hold the CANCEL button. The counter is reset when all the LEDs flash in sequence.

18