Summit HL-630 OPC manual Samsung CLP-300 Toner Cartridges, Samsung CLP-500 Toner Cartridges

will momentarily press in a lever inside the machine and start to reset the counter. The tape will then break releasing the lever finishing the reset procedure. Make sure you use a thin tape and not a packing tape, as it is important that the tape break fairly easily.

Samsung CLP-300 Toner Cartridges

Samsung Toner Cart. # CLP-K300A, CLP-

C300A, CLP-M300A, CLP-Y300A

Samsung OPC Cartridge Part # CLP-R300A

OEM Stated Toner Yield: 2,000 Black, 2,000

Color

OEM Stated Yield OPC 20,000 Black, 12,500

Color

The toner cartridges for these machines all use a chip that must be replaced each cycle. At the time of this writing, the chips are in development, but they should be available by the time you read this.

Samsung CLP-500 Toner Cartridges

Samsung Toner Cart. # CLP-500D7K, CLP-

500D5C, CLP-500D5M, CLP-500D5Y

OEM Stated Yield: 7,000 Black, 5,000 Color

Samsung OPC Cartridge Part # CLP-

500RB/XAA

Toner Cartridge: These cartridges have a flame proof resistor that must be replaced each cycle. The resistor is a 56 Ohm 1/4W FLAME PROOF type, and is located in a small connector on the side of the cartridge. It is extremely important that the correct FLAME PROOF resistor be used or printer damage and/or a printer fire may occur!

Drum Cartridge: Press the MENU button

Press the RIGHT ARROW button 4x until “Setup” shows on the display. Press ENTER. Press the RIGHT ARROW button 5x until “Maintenance” shows on the display. Press ENTER. Press the RIGHT ARROW button until “Check others” shows on the display. Press ENTER. Press the RIGHT ARROW button until “Imaging unit” shows on the display. Press ENTER. Press the RIGHT ARROW button until “Reset” shows on the display. Press ENTER. The counter is reset!

Samsung CLP-510 Toner/OPC

Cartridges

Samsung Cart. # CLP-510D7K, CLP-510D5C,

CLP-510D5M, CLP-510D5Y

OEM Stated Yield: 7,000 Black, 5,000 Color

Toner Cartridge: While these cartridges look at first glance identical to the CLP-500, they are different. The biggest difference is that they use a chip instead of a resistor to reset the printer. The chip must be replaced/reset each cycle. Reset boxes are available to reset the OEM as well as aftermarket chips. Some reset boxes will also allow the change from one manufacturer to another.

Drum Cartridge: Press the MENU button

Press the RIGHT ARROW button 4x until “Setup” shows on the display. Press ENTER. Press the RIGHT ARROW button 5x until “Maintenance” shows on the display. Press ENTER. Press the RIGHT ARROW button until “Check others” shows on the display. Press ENTER. Press the RIGHT ARROW button until “Imaging unit” shows on the display. Press ENTER. Press the RIGHT ARROW button until “Reset” shows on the display. Press ENTER. The counter is reset!

30