Summit HL-630 OPC manual Sharp AR-152 Toner Cartridges, Sharp AR-150 OPC, Sharp AL-1641/55/61 OPC

actuator (or flag) is next to the small gear). On some cartridges the "flag gear" is now black. It is located to the bottom right of the white gear. Make sure that when you snap the green end cap back on, the notch on the small gear lines up with the tab on the large single gear that is on the cartridge. Once everything lines up, snap the end cap in place. This is tricky, take your time!

To reset the starter cartridge, or any cartridge through the menu, do the following:

Enter the diagnostics menu by turning the machine on, and within 4 seconds, press "CLEAR", "EXPOSURE MODE", "CLEAR", "EXPOSURE MODE". (EXPOSURE MODE is the button on the far left). All of the display will go blank. Using the 10 and 1 buttons (copy quantity), enter "24" press "PRINT", enter "7" press "PRINT" again. The counter is now set to Zero!

Sharp AR-150 OPC

Sharp Cartridge Part # AR-150DR

OEM Stated Yield: 18,000

To reset the cartridge through the menu, do the following:

Enter the diagnostics menu by turning the machine on, and within 4 seconds, press "CLEAR", "EXPOSURE MODE", "CLEAR", "EXPOSURE MODE". (EXPOSURE MODE is the button on the far left). All of the display will go blank. Using the 10 and 1 buttons (copy quantity), enter "24" press "PRINT", enter "7" press "PRINT" again. The counter is now set to Zero!

Sharp AL-1641/55/61 OPC

Sharp Cartridge Part # Al-100DR

OEM Stated Yield: 18,000

These machines use the AL-110TD toner cartridge and have a different reset procedure then the normal AL-100DR machines use.

To reset the cartridge through the menu, do the following:

Enter the diagnostics menu by turning the machine on, and within 4 seconds, press “#” “ *” “CLEAR” “*” All of the display will go blank. Using the 10 and 1 buttons (copy quantity), enter "24" press "PRINT", enter "7" press "PRINT" again. The counter is now set to Zero!

Xerox WorkCentre Pro 16 Series OPC

Xerox Part # 13R563

OEM Stated Yield: 18,000

The actual procedure for these machines is not currently known. It is highly probable that the same procedures used in the Sharp AL-1000/Xerox XD- 100 will work but this is still being investigated. Look for updates on these machines on our web site www.summitechnologies.com

Xerox WorkCentre Pro 215 OPC

Xerox Part # 13R563

OEM Stated Yield: 18,000

The actual procedure for these machines is not currently known. It is highly probable that the same procedures used in the Sharp AL-1000/Xerox XD- 100 will work but this is still being investigated. Look for updates on these machines on our web site www.summitechnologies.com

.

Sharp AR-152 Toner Cartridges

Sharp Cartridge Part # AR-152NT

OEM Stated Yield: 6,500

These cartridges have a “Single Use Killer Chip”. This chip shuts down the cartridge after the first cycle so it will be necessary to replace it each time. Replacement chips for these cartridges are now available. The chip is installed in the back of the connector on the cartridge.

35