IBM ARTIC960RxD manual Installation, Hardware Requirements, Ibm, Dta

Page 11

Chapter 1. Installation

Each IBM ARTIC960RxD Quad DTA package includes the following:

Ÿ The IBM ARTIC960RxD PCI Adapter and Quad T1/E1 DTA pair

ŸThis book (with Warranty Statement)

Note: The IBM ARTIC960RxD Quad DTA is a Class A device.

The Federal Communications Commission (FCC) classification for this

product might differ from the FCC classification for your system unit. Use

classification that

is

highest. For

example,

if the

FCC

classification

for yo

system unit is

Class

B

and

a card

that

you

install

is

Class A, the

classifi

of your system

unit

would

change to

Class

A.

 

 

 

 

Hardware Requirements

The

IBM

ARTIC960RxD Quad

DTA

requires a

32-bit, PCI slot. It can be installed in

any

PCI-compliant computer

with

a fixed

frequencyNotPCI bus clock,

spread-spectrum

.

 

 

 

Chapter 1. Installation1-1

Image 11
Contents IBM Local Law 1999Contents Index IECSafety Information Vi Installation and Users Guide Handling Static Sensitive Devices Viii Installation and Users Guide Trademarks This BookISO Related InformationInstallation and Users Guide DTA InstallationHardware Requirements IBMRTE InstallationVersion Or later ForBefore installing this adapter, set jumper JP01 as follows Jumper Installation InformationQuad Digital Trunk PCI Adapter InstallingPCI Adapter Internal Cabling 100, 4-Drop CablingDigital Cable 100, 4-Drop Cable With SC-Bus Converter ConnectorConnecting Telecommunications Cables TheProgram DiagnosticsUnavailable PCI Product DescriptionPart Numbers PLX Features and FunctionIBM ARTIC960RxD PCI Adapter-Base Adapter ROMVlsi Quad T1/E1 DTA-Mezzanine CardComponent Locations AIX SpecificationsOptional Cables Publications6Installation and Users Guide T1/E1 Reinstalling the Quad T1/E1 DTABefore You Begin Quad T1/E1Check System Pre-Requisites InstallingDriver SystemPrompt Then Install Images Higher InstallWorkstation No Prerequisite Driver devices.artic96ð Install Device Drivers on the SP Nodes Diagnostic Testing TroubleshootingProblem Determination Procedures Diagnostic Wrap Cables and Connectors E1 BNC grounded and ungrounded T1 RJ-48, E1 RJ-48 T1 DB-15, and E1 DB-15T1/E1 DTA Port SpeedsIndividual Signals For All Ports Connect Quad T1/E1 RJ-48 Jack Connector DB-15 Connector BNC E1 BNC Connector GroundedE1 BNC Connector Ungrounded European Union EU Statement StatementMinistère des Safety RequirementsInternational Electrotechnical Commission IEC Statement AvisElectromagnetic Interference EMI Statement Taiwan Vcci StatementFIC Radio Protection for GermanyCanada Telecommunications Statement Norway and Sweden Telecommunications Statement New Zealand Telecommunications StatementEDO IndexBNC 2Installation and Users Guide Readers Comments Wed Like to Hear From You Business Reply Mail Page IBM