Appendix A. | Communications Statements |
|
|
|
|
|
|
|
|
|
|
| ||||
The | following statement applies to this product. The statement for other products | |||||||||||||||
intended | for | use | with | this | product | appears | in | their | accompanying | documentation. | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
Federal | Communications | Commission | (FCC) | Statement |
|
|
|
|
|
|
|
|
|
| ||
Note: | This | equipment | has been tested | and | found | to | comply with | the | limits | for a | ||||||
Class | A digital device, | pursuant to Part | 15 | of | the | FCC | Rules. | These limits | are |
designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to caus harmful interference in which case the user will be required to correct the interference at his own expense.
Properly | shielded and grounded cables and connectors | must | be used in | order to | ||
meet | FCC | emission limits. Neither the provider nor the | manufacturer | are | responsible | |
for | any | radio or television interference caused by | using | other | than | recommended |
cables and connectors or by unauthorized changes or modifications to this | ||||||
equipment. Unauthorized changes or modifications could void the user's | authority t | |||||
operate | the equipment. |
|
|
|
|
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and this device must accept any interference received, including interference that m cause undesired operation.
European Union (EU) Statement
This product is in conformity with the protection requirements of EU Council Direc 89/336/EEC on the approximation of the laws of the Member States relating to electromagnetic compatibility. The manufacturer cannot accept responsibility for any failure to satisfy the protection requirements resulting from a
This product has been tested and found to comply with the limits for Class A Information Technology Equipment according to CISPR 22 / European Standard EN
55022. The limits for Class A equipment were derived for commercial and industrial
Appendix A.