IBM ARTIC960RxD manual Install Device Drivers on the SP Nodes

g. Move the cursor untilfileset thenames and type:

devices.artic96ð

h. Press Enter to start the SPOT update. This operation can take up to

15minutes.

6.Proceed to section “Install Device Drivers on the SP Nodes”

Install Device Drivers on the SP Nodes

1. Make sure that the lppsource directory is exported to the Nodes by typing:

showmount -e

at the system prompt. The result should be something of the form:

/spdata/sys1/install/AIX432/lppsource (everyone)

2.If the directory is not exported, you may temporarily export the directory b typing:

exportfs -i /spdata/sys1/install/<lppsoruce_name>/lppsource

3. NFS	Mount	the lppsource directory by				typing:
dsh mount <controlwks>:
/spdata/sys1/install/<lppsource_name>/lppsource /mnt
at	the	system	prompt<controlwks.		> is the name of the		Control Workstation
known	for	the	Nodes<lppsource.	_name> is the name you			recorded earlier in
section		“Check	System Pre-Requisites”			on page 4-1.

4. Perform a preview of the files to be installed on the nodes by typing:

dsh "installp -p -acqXd /mnt device driver 2>&1" more

at the system promptdevice.	driveris the filesets that must be installed for
the adapter. The list	includes:

Ÿ No Prerequisite Driver

Ÿdevices.artic960

5. Then perform the device driver installation by typing:

dsh "installp -acqXd /mnt device driver 2>&1" more

at the system promptdevice. driveris defined in the previous step.

6.If the device driver is already installed on the node, contact your service provider to have the adapter installed.

4-6Installation and User's Guide