9.Record the name that appearslpp ourcebelowname for each node on which the adapters are being installed; you use this later.
__________________________________
10. Check if the device driver is installed in the lppsource directory by ty
cd /spdata/sys1/install/<lppsource_name>/lppsource
at the system prom<lppsourcet._name> was recorded in the previous step. Once in this directory, type:
ls devices.artic96ð\
at the system prompt to see if the fileset is in lppsource directory.
11.If the device driver is not in the lppsource directory, proceed to se “Install Software on the Control Workstation” on page
12. Update the SPOT (Shared Product Object Tree) by:
a. Type
smitty nim_res_op
at the system promptResource. TheName | panel | displays with | ||||
boot | resources | boot |
|
|
| |
highlighted. |
|
|
|
| ||
b. Move | the | cursor down | untilSPOT resourcethe | is | highlighted. The | |
SPOT | resource should look | like: |
|
|
| |
spot_AIX432 resources spot
The format of the spot name<lppsourceis: spotname>.
<lppsource_name> was recorded in a previous step.
c. When theSPOT resource is highlighted, press Enter to select this
option. TheNetwork Install Operation to Perform panel displays with thereset option highlighted for selection.
d. Move | the | cursor untilcust | theoption is | highlighted and | press Enter | |
to select | this optionCustomize. Thea SPOT panel | displays | with | |||
theSource | of | Install Images | highlighted | for | selection. |
|
e. Press F4 to display the list of Install Images and select the appropriate lppsource.
f. Move the cursor until the appropriate lppsource is displayed. For example:
lppsource_AIX432 resources lpp_source
Chapter 4. Installing the Device Driver on