IBM ARTIC960RxD manual Workstation, Install, Higher

g. Move	the cursor	untilfileset thenames	and type:
devices.artic96ð
h. Press	Enter to	start the SPOT	update. This operation can take up to
15 minutes.

13. Check if the software is already installed by typing:

dsh "lslpp -l devices.artic96ð\ 2>&1" more

at the system prompt.

14.If the device driver is already installed on the Node, contact your service provider to have the adapter installed.

15.If the device driver is not installed on the Node, proceed to section “Install Device Drivers on the SP Nodes” on page 4-6.

Install

Software

on

the

Control

Workstation

Note:

If

your

system is

"partitioned" i.e. there are more than one operating system

among

the

nodes, youonlymay install

this

adapter in

nodes4.2.1thaandt have

higher .

1. If

you

are

not

logged

into

the

Control

Workstation as a root user, log in now.

You

may

also

need

to

export

the

working

collective. Refer to section “Check

System

Pre-Requisites”

on

page 4-1.

2. Select the appropriate operating system media.

Table 4-1. Device Driver Sources

AIX 4.3.xIBM ARTIC960 RTE Disk Kit

AIX 4.2.1IBM ARTIC960 RTE Disk Kit

3. Insert the installation media into the Control Workstation's drive.

4. Transfer the files to the Control Workstation's lppsource, as follows:

a.Type

smitty bffcreate

then	press	Enter.
b. Select the		input	device/directory. Press F4 then move the cursor to
the	appropriate		input device and press Enter.

4-4Installation and User's Guide