
U S E R RESPONSIBLE F O R V E R I F Y I N G VERSION A N D COMPLETENESS
O E M F U N C T I O N A L S P E C I F I C A T I O N U L T R A S T A R X P ( D F H C ) SSA M O D E L S 1.12/2.25 G B - 1.0" H I G H
8.0Standards
8.1Safety
U N D E R W R I T E R S L A B O R A T O R Y (UL) APPROVAL:
The product is approved as a Recognized Component for use in Information Technology Equipment according to U L 1950 (without any Code 3 deviations). The U L Recognized Component marking is located on the product.
C A N A D I A N S T A N D A R D S ASSOCIATION (CSA) APPROVAL:
The product is certified to
I N T E R N A T I O N A L E L E C T R O T E C H N I C A L COMMISSION (IEC) S T A N D A R D S
The product is certified to comply to EN60950 (IEC 950 with European additions) by T U V Rheinland. The T U V Rheinland Bauart mark is located on the product.
SAFE H A N D L I N G :
The product is conditioned for safe handling in regards to sharp edges and corners.
E N V I R O N M E N T :
IBM will not knowingly or intentionally ship any units which during normal intended use or foreseeable misuse, would expose the user to toxic, carcinogenic, or otherwise hazardous substances at levels above the limitations identified in the current publications of the organizations listed below.
International Agency for Research on Cancer (IARC)
National Toxicology Program (NTP)
Occupational Safety and Health Administration (OSHA)
American Conference of Governmental Industrial Hygienists (ACGIH)
California Governor's List of Chemical Restricted under California Safe Drinking Water and Toxic Enforcement Act 1986 (also known as California Proposition 65)
S E C O N D A R Y C I R C U I T P R O T E C T I O N R E Q U I R E D I N U S I N G SYSTEMS
IBM has exercised care not to use any unprotected components or constructions that are particularly likely to cause fire. However, adequate secondary overcurrent protection is the responsibility of the user of the product. Additional protection against the possibility of sustained combustion due to circuit or component failure may need to be implemented by the user with circuitry external to the product. Over- current limit to the drive of 10 Amps or less should provide sufficient protection.
8.2 Electromagnetic Compatibility (EMC)
F C C Requirements
Pertaining to the disk drive, IBM will provide technical support to assist users in complying with the
United States Federal Communications Commission (FCC) Rules and Regulations, Part 15, Subpart J
Computing Devices “Class A and B Limits”. Tests for conformance to this requirement are performed with the disk drive mounted in the using system.
VDE Requirements
Source filename=STANDARD | I B M Corporation | Page 85 of 87 |