Cisco Systems (VIP6-80) manual Bottom ejector lever Processor module slot Module

Page 17

Figure 3 shows a detail of the ejector lever mechanism on the ends of the VIP.

Figure 3 Ejector Levers and Captive Installation Screws on the VIP6-80—Vertical Orientation Shown

a

Bottom ejector lever

Processor module slot

Processor

module

carrier guide

Captive

installation

screw

b

Stop

immediately

on contact

c

H1482a

Proceed to either the “Removing a VIP6-80” section on page 18 to replace a VIP6-80 or to the “Installing a VIP6-80” section on page 24 to install a new VIP6-80.

To install or remove a port adapter, see the “Removing and Installing Port Adapters” section on page 19.

Versatile Interface Processor (VIP6-80) Installation and Configuration Guide

	OL-5078-01	17

Image 17

Contents Introduction ContentsRelated Documentation Product Description VIP6-80 Features Memory Components CPUJumpers LEDsMicrocode ROM MonitorPA-2FE-TX Port Adapter SlotsPA-2FE-FX System Software SpecificationsTraffic Management Installation PrerequisitesSoftware Requirements Hardware RequirementsTools and Parts Required Agency Approvals Safety GuidelinesMicrocode Requirements Safety Warnings Electrical Equipment Guidelines Telephone Wiring GuidelinesPreventing Electrostatic Discharge Damage Guidelines for Removal and Installation Handling Interface Processors-Vertical Orientation Shown Bottom ejector lever Processor module slot Module Removing a VIP6-80 Removing and Installing Port Adapters Handling a Port Adapter Single-Width Port AdapterRemoving and Installing a Single-Width Port Adapter Location of VIP6-80 Slot Divider and Screws Dual-Width Port AdapterRemoving and Installing a Dual-Width Port Adapter Connecting Cables to the Port Adapter Installing a VIP6-80Performing a Basic Configuration Verifying the Installation Checking the VIP6-80 InstallationRemoval InsertionPage Using show Commands to Verify the VIP6-80 Status Router# show controllers cbus Using show Commands to Display Interface InformationShow controllers command RMA Using the ping Command to Verify Network ConnectivityUpgrading VIP6-80 Memory Maintenance ProceduresSingle Line Card Reload Product Description Opening the Dimm Socket Tabs Removing Sdram DIMMsInserting the Dimm Installing Sdram DIMMsChecking the VIP6-80 Memory Upgrade TroubleshootingCisco.com Obtaining DocumentationDocumentation CD-ROM Ordering DocumentationCisco TAC Website Opening a TAC Case Obtaining Technical AssistanceDocumentation Feedback TAC Case Priority Definitions Obtaining Additional Publications and InformationOL-5078-01