Cisco Systems (VIP6-80) manual Installing Sdram DIMMs, Inserting the Dimm

Page 35

Step 8 Repeat Step 4 through Step 7 for the remaining DIMM, if required for your upgrade.

This completes the DIMM removal procedure.

Installing SDRAM DIMMs

With the VIP6-80 handle away from you and the bus connector toward you, use the following procedure to install the new DIMM in the DIMM socket:

Step 1 Remove the new DIMM from its antistatic container.

Step 2 Hold the DIMM between your thumbs and forefingers. (See Figure 8.)

Note The 64-MB DIMM should be facing component-side down.

Step 3 Insert the connector edge of the DIMM straight into the socket.

Caution When inserting the DIMM, use firm but not excessive pressure. If you damage a socket, you will have to return the VIP6-80 to the factory for repair.

Step 4 Gently push the DIMM into the socket until the socket tabs close over the ends of the DIMM. (See Figure 11.) If necessary, rock the DIMM gently back and forth to seat it properly.

Figure 11 Inserting the DIMM

13418

Step 5 Check to see if the DIMM is seated properly. If the DIMM appears misaligned, carefully remove it and reseat it in the socket. Push the DIMM firmly back into the socket until first one and then the other socket tab moves into place.

Step 6 Repeat Step 1 through Step 5 above if you are replacing more than one DIMM.

This completes the DIMM replacement procedure. Reinstall the VIP6-80 in the system. (Follow the steps in the “Installing a VIP6-80” section on page 24.) See the following section, “Checking the VIP6-80 Memory Upgrade,” as required.

Versatile Interface Processor (VIP6-80) Installation and Configuration Guide

	OL-5078-01	35

Image 35

Contents Introduction ContentsRelated Documentation Product Description VIP6-80 Features Memory Components CPUROM Monitor LEDsJumpers MicrocodePA-2FE-TX Port Adapter SlotsPA-2FE-FX System Software SpecificationsHardware Requirements Installation PrerequisitesTraffic Management Software RequirementsTools and Parts Required Agency Approvals Safety GuidelinesMicrocode Requirements Safety Warnings Electrical Equipment Guidelines Telephone Wiring GuidelinesPreventing Electrostatic Discharge Damage Guidelines for Removal and Installation Handling Interface Processors-Vertical Orientation Shown Bottom ejector lever Processor module slot Module Removing a VIP6-80 Removing and Installing Port Adapters Handling a Port Adapter Single-Width Port AdapterRemoving and Installing a Single-Width Port Adapter Location of VIP6-80 Slot Divider and Screws Dual-Width Port AdapterRemoving and Installing a Dual-Width Port Adapter Connecting Cables to the Port Adapter Installing a VIP6-80Performing a Basic Configuration Insertion Checking the VIP6-80 InstallationVerifying the Installation RemovalPage Using show Commands to Verify the VIP6-80 Status Router# show controllers cbus Using show Commands to Display Interface InformationShow controllers command RMA Using the ping Command to Verify Network ConnectivityUpgrading VIP6-80 Memory Maintenance ProceduresSingle Line Card Reload Product Description Opening the Dimm Socket Tabs Removing Sdram DIMMsInserting the Dimm Installing Sdram DIMMsChecking the VIP6-80 Memory Upgrade TroubleshootingOrdering Documentation Obtaining DocumentationCisco.com Documentation CD-ROMCisco TAC Website Opening a TAC Case Obtaining Technical AssistanceDocumentation Feedback TAC Case Priority Definitions Obtaining Additional Publications and InformationOL-5078-01