Cisco Systems (VIP6-80) manual Single-Width Port Adapter, Handling a Port Adapter

Page 20

Figure 4 Handling a Port Adapter

Metal carrier

Printed circuit board

H6420

Single-Width Port Adapter

Single-width port adapters occupy one of the two port adapter slots on a VIP6-80. When a single-width port adapter slot is not in use, use a blank port adapter to fill the empty slot to allow the router to conform to EMI emissions requirements and to allow proper airflow through the router. If you plan to install a new single-width port adapter in a port adapter slot that is not in use, first remove the blank port adapter.

Figure 5 describes the steps required to install a single-width port adapter.

Versatile Interface Processor (VIP6-80) Installation and Configuration Guide

20

OL-5078-01

 

 

Image 20
Contents Contents IntroductionRelated Documentation Product Description VIP6-80 Features CPU Memory ComponentsLEDs JumpersMicrocode ROM MonitorPort Adapter Slots PA-2FE-TXPA-2FE-FX Specifications System SoftwareInstallation Prerequisites Traffic ManagementSoftware Requirements Hardware RequirementsTools and Parts Required Agency Approvals Safety GuidelinesMicrocode Requirements Safety Warnings Telephone Wiring Guidelines Electrical Equipment GuidelinesPreventing Electrostatic Discharge Damage Guidelines for Removal and Installation Handling Interface Processors-Vertical Orientation Shown Bottom ejector lever Processor module slot Module Removing a VIP6-80 Removing and Installing Port Adapters Single-Width Port Adapter Handling a Port AdapterRemoving and Installing a Single-Width Port Adapter Dual-Width Port Adapter Location of VIP6-80 Slot Divider and ScrewsRemoving and Installing a Dual-Width Port Adapter Installing a VIP6-80 Connecting Cables to the Port AdapterPerforming a Basic Configuration Checking the VIP6-80 Installation Verifying the InstallationRemoval InsertionPage Using show Commands to Verify the VIP6-80 Status Using show Commands to Display Interface Information Router# show controllers cbusShow controllers command Using the ping Command to Verify Network Connectivity RMAUpgrading VIP6-80 Memory Maintenance ProceduresSingle Line Card Reload Product Description Removing Sdram DIMMs Opening the Dimm Socket TabsInstalling Sdram DIMMs Inserting the DimmTroubleshooting Checking the VIP6-80 Memory UpgradeObtaining Documentation Cisco.comDocumentation CD-ROM Ordering DocumentationCisco TAC Website Opening a TAC Case Obtaining Technical AssistanceDocumentation Feedback Obtaining Additional Publications and Information TAC Case Priority DefinitionsOL-5078-01