Cisco Systems (VIP6-80) manual Cpu, Memory Components

Page 5

Figure 1

VIP6-80

1

6

2

75368

5

			3
	4
1	Bus connector	4	Port adapter slot 1
2	CPU	5	Port adapter slot 0
3	SDRAM DIMM (program or CPU memory) U1	6	SDRAM DIMM (packet memory) U5

CPU

Table 2	CPU

				Location
Type		Size	Description	(See Figure 1.)

CPU		400 megahertz (MHz)	Reduced Instruction Set Computer (RISC),	CPU
		internal operating frequency	MIPS R7000 processor

Memory Components

You can use any combination of available CPU memory configurations and packet memory configurations on the VIP6-80. You do not need to have equal amounts of CPU memory and packet memory installed. (For information about upgrading memory, see the “Upgrading VIP6-80 Memory” section on page 32.) For a description of memory components, see Table 3.

Versatile Interface Processor (VIP6-80) Installation and Configuration Guide

	OL-5078-01	5

Image 5

Contents Introduction ContentsRelated Documentation Product Description VIP6-80 Features Memory Components CPUJumpers LEDsMicrocode ROM MonitorPA-2FE-TX Port Adapter SlotsPA-2FE-FX System Software SpecificationsTraffic Management Installation PrerequisitesSoftware Requirements Hardware RequirementsTools and Parts Required Agency Approvals Safety GuidelinesMicrocode Requirements Safety Warnings Electrical Equipment Guidelines Telephone Wiring GuidelinesPreventing Electrostatic Discharge Damage Guidelines for Removal and Installation Handling Interface Processors-Vertical Orientation Shown Bottom ejector lever Processor module slot Module Removing a VIP6-80 Removing and Installing Port Adapters Handling a Port Adapter Single-Width Port AdapterRemoving and Installing a Single-Width Port Adapter Location of VIP6-80 Slot Divider and Screws Dual-Width Port AdapterRemoving and Installing a Dual-Width Port Adapter Connecting Cables to the Port Adapter Installing a VIP6-80Performing a Basic Configuration Verifying the Installation Checking the VIP6-80 InstallationRemoval InsertionPage Using show Commands to Verify the VIP6-80 Status Router# show controllers cbus Using show Commands to Display Interface InformationShow controllers command RMA Using the ping Command to Verify Network ConnectivityUpgrading VIP6-80 Memory Maintenance ProceduresSingle Line Card Reload Product Description Opening the Dimm Socket Tabs Removing Sdram DIMMsInserting the Dimm Installing Sdram DIMMsChecking the VIP6-80 Memory Upgrade TroubleshootingCisco.com Obtaining DocumentationDocumentation CD-ROM Ordering DocumentationCisco TAC Website Opening a TAC Case Obtaining Technical AssistanceDocumentation Feedback TAC Case Priority Definitions Obtaining Additional Publications and InformationOL-5078-01