Cisco Systems (VIP6-80) Dual-Width Port Adapter, Location of VIP6-80 Slot Divider and Screws

Page 22

Dual-Width Port Adapter

Dual-width port adapters occupy both port adapter slots on a VIP6-80. Before you can install a dual-width port adapter, first remove the slot divider located between the two port adapter slots. (See Figure 6.) Refer to Table 4 for a list of dual-width port adapters.

Figure 6 Location of VIP6-80 Slot Divider and Screws

27871

Screw holes for septum

Use the following procedure to remove the slot divider from a VIP6-80:

Step 1 Use a number 1 Phillips screwdriver to remove the screw located at the rear of each port adapter slot (see Figure 7).

Step 2 Remove the four slot divider screws that secure the slot divider to the VIP6-80 motherboard. (See Figure 6.)

Step 3 Remove the slot divider and store it (and the screws) in a location where you can retrieve it for use later.

Note If you need to reinstall the port adapter slot divider, place the slot divider in position on the VIP6-80 and secure it with the four Phillips screws.

Step 4 See Figure 7 for the steps to install or remove a dual-width port adapter.

Versatile Interface Processor (VIP6-80) Installation and Configuration Guide

22	OL-5078-01

Image 22

Contents Contents IntroductionRelated Documentation Product Description VIP6-80 Features CPU Memory ComponentsMicrocode LEDsJumpers ROM MonitorPort Adapter Slots PA-2FE-TXPA-2FE-FX Specifications System SoftwareSoftware Requirements Installation PrerequisitesTraffic Management Hardware RequirementsMicrocode Requirements Agency Approvals Safety GuidelinesTools and Parts Required Safety Warnings Telephone Wiring Guidelines Electrical Equipment GuidelinesPreventing Electrostatic Discharge Damage Guidelines for Removal and Installation Handling Interface Processors-Vertical Orientation Shown Bottom ejector lever Processor module slot Module Removing a VIP6-80 Removing and Installing Port Adapters Single-Width Port Adapter Handling a Port AdapterRemoving and Installing a Single-Width Port Adapter Dual-Width Port Adapter Location of VIP6-80 Slot Divider and ScrewsRemoving and Installing a Dual-Width Port Adapter Installing a VIP6-80 Connecting Cables to the Port AdapterPerforming a Basic Configuration Removal Checking the VIP6-80 InstallationVerifying the Installation InsertionPage Using show Commands to Verify the VIP6-80 Status Using show Commands to Display Interface Information Router# show controllers cbusShow controllers command Using the ping Command to Verify Network Connectivity RMASingle Line Card Reload Maintenance ProceduresUpgrading VIP6-80 Memory Product Description Removing Sdram DIMMs Opening the Dimm Socket TabsInstalling Sdram DIMMs Inserting the DimmTroubleshooting Checking the VIP6-80 Memory UpgradeDocumentation CD-ROM Obtaining DocumentationCisco.com Ordering DocumentationDocumentation Feedback Obtaining Technical AssistanceCisco TAC Website Opening a TAC Case Obtaining Additional Publications and Information TAC Case Priority DefinitionsOL-5078-01