Cisco Systems (VIP6-80) manual Removing Sdram DIMMs, Opening the Dimm Socket Tabs

Page 34

Removing SDRAM DIMMs

Use the following procedure to remove the existing DIMMs:

Step 1 Turn off the system power and remove the VIP6-80 from the system. (Follow the steps in the “Removing a VIP6-80” section on page 18.)

Step 2 Place the VIP6-80 on an antistatic mat or pad and ensure that you are wearing an antistatic device, such as a wrist strap.

Step 3 Position the VIP6-80 so that the handles are away from you and the bus connectors are toward you—opposite of the position shown in Figure 2.

Step 4 Locate the DIMM and position the VIP6-80 so that you are facing the DIMM module you want to remove.

Step 5 Open the DIMM socket tabs on the DIMM to release the DIMM from the socket. (See Figure 9.) The DIMM is under tension in the socket; therefore, the DIMM might be released from the socket with some force.

Figure 9 Opening the DIMM Socket Tabs

Pull the tabs away with

your thumbs, bracing your

forefingers against the

DIMM socket sides

SDRAM DIMM

13339

Step 6 With the DIMM socket tabs open, grasp the ends of the DIMM between your thumbs and forefingers and pull the DIMM completely out of the socket. (See Figure 10.)

Figure 10 Removing the DIMM

Polarization notch

Metal fingers

13341

Step 7 Place a removed DIMM on an antistatic mat, and store it in an antistatic container to protect it from ESD damage.

Versatile Interface Processor (VIP6-80) Installation and Configuration Guide

34

OL-5078-01

 

 

Image 34
Contents Contents IntroductionRelated Documentation Product Description VIP6-80 Features CPU Memory ComponentsMicrocode LEDsJumpers ROM MonitorPort Adapter Slots PA-2FE-TXPA-2FE-FX Specifications System SoftwareSoftware Requirements Installation PrerequisitesTraffic Management Hardware RequirementsMicrocode Requirements Agency Approvals Safety GuidelinesTools and Parts Required Safety Warnings Telephone Wiring Guidelines Electrical Equipment GuidelinesPreventing Electrostatic Discharge Damage Guidelines for Removal and Installation Handling Interface Processors-Vertical Orientation Shown Bottom ejector lever Processor module slot Module Removing a VIP6-80 Removing and Installing Port Adapters Single-Width Port Adapter Handling a Port AdapterRemoving and Installing a Single-Width Port Adapter Dual-Width Port Adapter Location of VIP6-80 Slot Divider and ScrewsRemoving and Installing a Dual-Width Port Adapter Installing a VIP6-80 Connecting Cables to the Port AdapterPerforming a Basic Configuration Removal Checking the VIP6-80 InstallationVerifying the Installation InsertionPage Using show Commands to Verify the VIP6-80 Status Using show Commands to Display Interface Information Router# show controllers cbusShow controllers command Using the ping Command to Verify Network Connectivity RMASingle Line Card Reload Maintenance ProceduresUpgrading VIP6-80 Memory Product Description Removing Sdram DIMMs Opening the Dimm Socket TabsInstalling Sdram DIMMs Inserting the DimmTroubleshooting Checking the VIP6-80 Memory UpgradeDocumentation CD-ROM Obtaining DocumentationCisco.com Ordering DocumentationDocumentation Feedback Obtaining Technical AssistanceCisco TAC Website Opening a TAC Case Obtaining Additional Publications and Information TAC Case Priority DefinitionsOL-5078-01