Cisco Systems N3KC3524P10G manual Ports for the Cisco Nexus 3548 Switch

Chapter 1 Overview of the Cisco Nexus 3000 Series Switches

Cisco Nexus 3548 Switch

Se n d d o c u m e n t c o m m e n t s t o n ex u s 3 k - d o c f e e d b a ck @ c i sc o . c o m

Figure 1-8 Rear View of the Cisco Nexus 3548 Switch

1

One pps port, one console port , one USB port, one management port

2

48fixed Small Form-Factor Pluggable (SFP+) ports

Ports for the Cisco Nexus 3548 Switch

The switch chassis includes the following ports:

•Fixed 1- and 10-Gigabit Ethernet Small Form-Factor Pluggable (SFP+) ports (48 ports)

•1-PPS timing port (1 port)

•10/100/1000 management ports (2 ports)

•Console port (1 port)

•USB port (1 port)

The chassis has 48 1- and 10-Gigabit Ethernet ports that you connect to servers, which are often in the same rack or a nearby rack. You use Small Form factor Pluggable Plus (SFP+) transceivers with copper or optical cables to connect the switch to the servers. The ports are numbered from left to right from 1 to 48 with the odd-numbered ports on top and the even-numbered ports on the bottom.

You useone 1-PPS timing port, with the RF1.0/2.3 QuickConnect connector type.

Two 100/1000 Ethernet management ports enable you to manage switch operations. You can connect to the switch through these two ports by using an RJ-45 connector on a copper cable.

One RS-232 serial console port enables you to initially configure the switch and to perform troubleshooting operations.

One USB port enables you to save or load switch configurations.

	Cisco Nexus 3000 Series Hardware Installation Guide
1-18	OL-25338-04