Cisco Systems IE 3000 warranty Grounding the Switch, Inch 12.7 mm

Page 17

Cisco IE 3000 Switch Getting Started Guide

Step 4 Position the rear panel of the switch directly in front of the DIN rail, making sure that the DIN rail fits in the space between the two latches.

DIN rail

202339

Step 5 Push the DIN rail latches in after the switch is over the DIN rail to secure the switch to the rail. You hear a click when the latches are completely locked.

Step 6 Connect power to the switch.

See the wiring instructions in the “Grounding the Switch” section on page 17 and the “Wiring the DC Power Source” section on page 18.

Grounding the Switch

Follow these steps to connect the switch to a protective ground.

Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Step 1 Use a standard Phillips screwdriver or a ratcheting torque screwdriver with a Phillips head to remove the ground screw from the front panel of the switch. Store the ground screw for later use.

Step 2 Use a wire stripping tool to strip the 10- to 12-gauge ground wire to 0.5 inch (12.7 mm)

± 0.02 inch (0.5 mm).

0.5 inch (12.7 mm)

119516

 

 

Cisco IE 3000 Switch Getting Started Guide

 

 

 

 

 

 

OL-16234-01

 

 

17

 

 

 

Image 17
Contents About This Guide Cisco IE 3000 Switch Getting Started GuideTaking Out What You Need Connecting Expansion Modules 202334 203759 202335 Running Express Setup Connect power to the switch Connection Cisco IE 3000 Switch Getting Started Guide Refreshing the PC IP Address Managing the SwitchUsing the Device Manager Downloading Cisco Network Assistant Command-Line InterfaceOther Management Options Installing the SwitchBefore You Begin Equipment That You SupplyInstallation Warning Statements 140F 60C Statement Cisco IE 3000 Switch Getting Started Guide Foot Latch Mounting the Switch to a DIN Rail or to the Rack AdapterInch 12.7 mm Grounding the SwitchFollow these steps to prepare the DC power cable Wiring the DC Power SourceInch 6.6 mm Attaching the Power and Relay Connector Optional Procedures Connecting to the Switch PortsConnecting to 10/100 and 10/100/1000 Ports Installing SFP Modules and Connecting to Ports Verifying Port Connectivity Connecting to Dual-Purpose PortsConnecting to 100BASE-FX Ports Case of Difficulty Troubleshooting Express SetupResetting the Switch For More Information Accessing Online HelpCisco One-Year Limited Hardware Warranty Terms Obtaining Documentation and Submitting a Service RequestDuration of Hardware Warranty To Receive a Return Materials Authorization RMA Number Cisco IE 3000 Switch Getting Started Guide Cisco IE 3000 Switch Getting Started Guide