Cisco Systems IE 3000 warranty Inch 6.6 mm

Page 19

Cisco IE 3000 Switch Getting Started Guide

Warning This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than: 5A. Statement 1005

Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030

Step 1 Locate the power and relay connector. 201815

Step 2 Identify the positive and return DC power connections on the connector. The positive DC power connection is labeled V, and the return is the adjacent connection labeled RT.

Step 3 Measure a strand of twisted-pair copper wire (18- to 20-AWG) long enough to connect to the DC power source.

Step 4 Using an 18-gauge wire-stripping tool, strip each of the two wires to 0.25 inch (6.3 mm) ±

0.02inch (0.5 mm). Do not strip more than

0.27inch (6.8 mm) of insulation from the wire. Stripping more than the recommended amount of wire can leave exposed wire from the connector after installation.

Step 5 Insert the exposed part of the positive wire into the connection labeled V and the exposed part of the return wire into the connection labeled RT. Make sure that you cannot see any wire lead. Only wire with insulation should extend from the connector.

0.27 inch (6.6 mm)

 

 

 

 

119591

 

 

 

 

 

 

 

 

 

 

 

V

 

RT

 

A

V

A

 

RT

202330

Step 6 Use a ratcheting torque flathead screwdriver to torque the power and relay connector captive screws (above the installed wire leads) to 2 in-lb, the maximum recommended torque.

 

 

Cisco IE 3000 Switch Getting Started Guide

 

 

 

 

 

 

OL-16234-01

 

 

19

 

 

 

Page 18 Page 20
Image 19
Page 18 Page 20
Contents About This Guide Cisco IE 3000 Switch Getting Started GuideTaking Out What You Need Connecting Expansion Modules 202334 203759 202335 Running Express Setup Connect power to the switch Connection Cisco IE 3000 Switch Getting Started Guide Using the Device Manager Managing the SwitchRefreshing the PC IP Address Downloading Cisco Network Assistant Command-Line InterfaceOther Management Options Installing the SwitchBefore You Begin Equipment That You SupplyInstallation Warning Statements 140F 60C Statement Cisco IE 3000 Switch Getting Started Guide Foot Latch Mounting the Switch to a DIN Rail or to the Rack AdapterInch 12.7 mm Grounding the SwitchFollow these steps to prepare the DC power cable Wiring the DC Power SourceInch 6.6 mm Attaching the Power and Relay Connector Optional Procedures Connecting to the Switch PortsConnecting to 10/100 and 10/100/1000 Ports Installing SFP Modules and Connecting to Ports Connecting to 100BASE-FX Ports Connecting to Dual-Purpose PortsVerifying Port Connectivity Case of Difficulty Troubleshooting Express SetupResetting the Switch For More Information Accessing Online HelpCisco One-Year Limited Hardware Warranty Terms Obtaining Documentation and Submitting a Service RequestDuration of Hardware Warranty To Receive a Return Materials Authorization RMA Number Cisco IE 3000 Switch Getting Started Guide Cisco IE 3000 Switch Getting Started Guide
Top Page Image Contents