Cisco Systems IE 3000 warranty Connect power to the switch

Page 6

Cisco IE 3000 Switch Getting Started Guide

To run Express Setup:

Step 1 Make sure that nothing is connected to the switch.

During Express Setup, the switch acts as a DHCP server. If your PC has a static IP address, change your PC settings before you begin to temporarily use DHCP.

201873

Step 2 Connect power to the switch.

See the wiring instructions in the “Grounding the Switch” section on page 17 and the “Wiring the DC Power Source” section on page 18.

Step 3 When the switch powers on, it begins the power-on self-test (POST). During POST, the System LED blinks while a series of tests verify that the switch functions properly. Wait for the switch to complete POST, which takes approximately 1 minute.

Step 4 Make sure that POST has completed by verifying that the System LED is solid green. If the switch has not been configured, the Setup LED blinks green. If the Setup LED stops blinking, you can still continue with the next step.

If the switch fails POST, the System LED turns red. See the “In Case of Difficulty” section on page 25 if your switch fails POST.

Step 5 Press the Express Setup button. This button is recessed behind the front panel, so you can use a simple tool, such as a paper clip.

When you press the Express Setup button, a switch port LED begins blinking green.

Express

 

Setup

 

System

 

Pwr

A

Alarm

 

Pwr

B

Setup

 

 

2

201877

Cisco IE 3000 Switch Getting Started Guide

6

OL-16234-01

 

 

Image 6
Contents Cisco IE 3000 Switch Getting Started Guide About This GuideTaking Out What You Need Connecting Expansion Modules 202334 203759 202335 Running Express Setup Connect power to the switch Connection Cisco IE 3000 Switch Getting Started Guide Managing the Switch Using the Device ManagerRefreshing the PC IP Address Command-Line Interface Downloading Cisco Network AssistantInstalling the Switch Other Management OptionsEquipment That You Supply Before You BeginInstallation Warning Statements 140F 60C Statement Cisco IE 3000 Switch Getting Started Guide Mounting the Switch to a DIN Rail or to the Rack Adapter Foot LatchGrounding the Switch Inch 12.7 mmWiring the DC Power Source Follow these steps to prepare the DC power cableInch 6.6 mm Attaching the Power and Relay Connector Connecting to the Switch Ports Optional ProceduresConnecting to 10/100 and 10/100/1000 Ports Installing SFP Modules and Connecting to Ports Connecting to Dual-Purpose Ports Connecting to 100BASE-FX PortsVerifying Port Connectivity Troubleshooting Express Setup Case of DifficultyResetting the Switch Accessing Online Help For More InformationObtaining Documentation and Submitting a Service Request Cisco One-Year Limited Hardware Warranty TermsDuration of Hardware Warranty To Receive a Return Materials Authorization RMA Number Cisco IE 3000 Switch Getting Started Guide Cisco IE 3000 Switch Getting Started Guide