Cisco Systems IE 3010 manual Wiring the Power Source, Loosen the Screws on the Power Supply Blank

Chapter 3 Power Supply Installation

Power-Supply Module Installation

Figure 3-6 Loosen the Screws on the Power Supply Blank

Cisco IE		3010
Sw
	itch Series

208382

Figure 3-7 Remove the Power Supply Blank

208383

Step 3 Insert the power-supply module into the slot, and gently push it in. See Figure 3-8. The power-supply module should be flush with the switch.

Figure 3-8 Insert the Power-Supply Module

208377

Step 4 Use a ratcheting torque screwdriver to torque each screw to 8–10 in-lb.

Wiring the Power Source

Before you wire the power source, review the warnings in this section:

Cisco IE 3010 Switch Hardware Installation Guide

78-19581-02 3-7