Cisco Systems IE 3010 manual USB Console Port, Figure C-2 Connecting the USB Console Cable

Appendix C Configuring the Switch with the CLI Setup Program

Accessing the CLI Through the Console Port

USB Console Port

Step 1 If you are connecting the switch USB console port to a Windows-based PC for the first time, install a USB driver. See Figure C-2.

•“Installing the Cisco Microsoft Windows XP USB Driver” section on page C-4

•“Installing the Cisco Microsoft Windows 2000 USB Driver” section on page C-4

•“Installing the Cisco Microsoft Windows Vista USB Driver” section on page C-5

Figure C-2 Connecting the USB Console Cable

1

2 1

2

3

1 USB console port 3 USB port on the PC

2USB cable

208379

Step 2 Connect an USB cable to the PC USB port. Connect the other end of the cable to the switch mini-B (5-pin-connector) USB console port. See Figure C-2.

Step 3 To identify the COM port assigned to the USB console port: Choose Start > Control Panel > Systems

Click the Hardware tab and choose Device Manager. Expand the Ports section. The assigned COM port appears in parenthesis at the end of the line with this entry: Cisco USB System Management Console.

Step 4 Start the terminal-emulation program on the PC or the terminal. The program, frequently a PC application such as HyperTerminal or ProcommPlus, makes communication possible between the switch and your PC or terminal.

Cisco IE 3010 Switch Hardware Installation Guide

78-19581-02 C-3