Options:
numSeconds
New timeout setting.
Sample Output:
Current NTP timeout value: 2 seconds
Current NTP timeout changed to 3 seconds
Note With no arguments, this command displays the current NTP timeout settings. This is the amount of time (in seconds) for the system to wait for a response from the NTP server. This setting can be configured by using the same command with the new timeout value (in whole seconds) as the only argument. The default settings is 2 seconds. The NTP timeout value is not used on linecards or slave CMUs.
timeNtpRefreshTime
Display or set the delay between syncing the clock via NTP.
Syntax:
timeNtpRefreshTime numSeconds
Options:
numSeconds
New refresh delay setting.
Sample Output:
Current NTP refresh delay value: 60 seconds
Current NTP refresh delay changed to 50 seconds.
Note With no arguments this command displays the current NTP refresh time, which is the delay in seconds between attempts to sync the clock via NTP. This value can be configured by using this same command with the new refresh time (in whole seconds) as the only argument. The NTP refresh time is not used on linecards or slave CMUs.
Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
| ||
|