Cisco Systems SFS 7012 manual Using the Chassis Viewer GUI

super

The system responds with:

Welcome to the SFS 7012 CLI. Type 'list' for the list of commands.

Step 6 To change the SFS 7012 default IP address enter:

setChassisIpAddr -h ipaddress -m netMask

where -h ipaddress is the new IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx) format, and -m netMask is the new subnet mask in dotted decimal (i.e., xxx.xxx.xxx.xxx) format.

Note After changing the IP address the chassis TELNET/SSH session is terminated and must be reopened using the new IP address.

Step 7 To change the SFS 7012 default gateway IP address enter:

setDefaultRoute -h ipaddress

where -h ipaddress is the new default gateway IP address in dotted decimal (i.e., xxx.xxx.xxx.xxx) format.

Step 8 To to exit the CLI enter:

logout

Using the Chassis Viewer GUI

Step 1 Power up the switch.

Step 2 Connect a Category 5 or 6 (Cat 5/6) Ethernet cable to the RJ-45 connector on spine 1. Connect the other end of the Cat 5/6 to an OOB LAN Ethernet hub or Ethernet switch where a work station can access the 7012. A work station can be connected directly to the Ethernet port of spine 1 of the 7012 if using a crossover Ethernet cable. Power up the switch.

Step 3 To start Chassis Viewer, open a web browser and enter the default IP of the switch (i.e., 192.168.100.9).

Note The browser must be on a workstation connected to the same Ethernet LAN, and on the same TCP/IP subnet as the switch RJ-45 OOB LAN port.

Note Chassis Viewer supports the following browsers: Microsoft Internet Explorer 6.0+ and Mozilla version 1.6.x+

Note If the user is leaving their workstation for a period of time, be sure to close the browser window.

Step 4 If web authentication is enabled, the following screen will be displayed:

Note If web authentication is not enabled, skip to Step 5.

Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide

OL-8787-05 1-23