15
NOTE: The power socket on the back (service end) of the Topspin 360 corresponds to the power supply module on the same side of the Server Switch.
Removing a Power Supply
To remove the power supply, perform the following steps:
1.Remove the power cord from the power supply.
2.Disengage the power supply by pulling it toward you.
3.Slide the power supply out of the chassis.
4.Fasten a blanking panel to the empty chassis bay to ensure appropriate cooling.
NOTE: The blanking panel is a flat sheet of metal with the same dimensions as the power module faceplate.
Blower Trays
The
Blower Tray | Blower Tray |
Figure 2-11: Blower Trays
NOTE: Your chassis requires two
Install Blower Trays
To insert a blower tray, perform the following steps:
1.Ground yourself appropriately.
2.Remove the blower tray from any packaging.