Cisco Systems SFS 3012 manual Update the switch card firmware. Enter the install command

43

•The keyword all (The CLI defaults to “all” if you enter just “show card”).

Example

Topspin-360#show card 5,9,14,16

============================================================================

Card Information

============================================================================

admin	oper	admin	oper	oper
slot type	type	status	status	code

----------------------------------------------------------------------------

5	en4port1G	en4port1G	up	up	normal
9	fc2port2G	fc2port2G	up	up	normal
14	controller	controller	up	up	normal
16	ib12port4x	ib12port4x	up	up	normal

============================================================================

Card Boot Information

============================================================================

boot	boot	boot
slot stage	status	image

----------------------------------------------------------------------------

5	done	success	TopspinOS-1.1.2/build084
9	done	success	TopspinOS-1.1.2/build084
14	done	success	TopspinOS-1.1.2/build084
16	done	success	TopspinOS-1.1.2/build084

============================================================================

Card Seeprom

============================================================================

product	pca	pca	fru
slot serial-number	serial-number	number	number

----------------------------------------------------------------------------

5	00024	1234	95-00007-01	1234
9	1234	1234	95-00008-01	1234
14	00002	00002	95-00005-01	1234
16	1234	1234	95-00006-01	1234

Topspin-360#

2.Update the switch card firmware. Enter the install command:

Example

Topspin-360#install image:Topspin-360-TopspinOS-2.0.0-build497.img

************************** operation completed successfully Topspin-360#

NOTE: Only cards with an oper-status of “up” are updated. If a card is down when you run install, or a card is added after running install, bring up the card and run install again. Specify the same image file. If the image is already installed on a card, that card is skipped. Run boot-config again so that all cards know to boot off the same system image.