Cisco Systems PA-4C-E 1 manual Port Adapter Removal and Installation

Page 23

Removing and Installing Port Adapters

Port Adapter Removal and Installation

In this section, the illustrations that follow give step-by-step instructions on how to remove and install port adapters. Although the procedures may refer to a particular type of port adapter, the steps are the same for installing and removing all types of port adapters. This section contains the following illustrations:

•Cisco 7200 Series Routers and Cisco 7200 VXR Routers—Removing and Installing a Port Adapter, page 24

Caution When performing the following procedures, wear a grounding wrist strap to avoid ESD damage to the card. Some platforms have an ESD connector for attaching the wrist strap.

Warning Hazardous voltage or energy is present on the backplane when the system is operating. Use caution when servicing. Statement 1034

Caution When powering off the router, wait a minimum of 30 seconds before powering it on again.

PA-4C-E 1-Port High-Performance ESCON Channel Port Adapter Installation and Configuration

	OL-3743-02	23

Image 23

Contents PA-4C-E 1-Port High-Performance Document Version Date Change Summary Document Revision HistoryObjectives OrganizationRelated Documentation OL-3743-02 Port Adapter Overview OverviewCisco 7206 with an HP Escon PA in Port Adapter Slot LEDs Escon SpecificationsCharacteristic Escon Specification Off Sequence Present Loaded Signal OnlinePort Adapter Slot Locations on the Supported Platforms Escon CablePort Adapter Slots in the Cisco 7206 Router Identifying Interface AddressesPlatform Interface Address Format Numbers Syntax HP Escon PA Microcode Overview Required Tools and EquipmentRouter# show microcode Hardware and Software RequirementsCisco IOS Release Image Names Checking Hardware and Software CompatibilitySafety Warnings Safety GuidelinesAviso Instruções Importantes DE Segurança Warnung Wichtige SicherheitshinweiseAvvertenza Importanti Istruzioni Sulla Sicurezza Spara Dessa Anvisningar Preventing Electrostatic Discharge Damage Laser LED Safety InformationElectrical Equipment Guidelines Laser Radiation Staring into Laser Beam Handling Port Adapters Removing and Installing Port AdaptersOnline Insertion and Removal Port Adapter Removal and Installation Step Attaching the HP Escon PA to the Channel Using the Exec Command Interpreter Configuring the HP Escon PARouter# configure terminal Configuring the HP Escon PA InterfacePerforming a Basic Interface Configuration Routerconfig-if#ip address 1.1.1.10 Checking the ConfigurationUsing show Commands to Verify the New Interface Status Routerconfig# interface channel 2/0Router# show version Using the show version or show hardware CommandsRouter# show controllers channel 2/0 Using the show controllers CommandsRouter# show interface channel 4/0 Using the show diag CommandRouter# ping Using the Ping Command to Verify Network ConnectivityUpgrading the HP Escon PA Microcode from Cisco.com Upgrading Your HP Escon PA MicrocodeHow Does HP Escon PA Microcode Ship? Router show flash Configuring the HP Escon PA MicrocodeRouterconfig# no microcode ecpa slot0xcpa28-1 Routerconfig# microcode ecpa slot0xcpa28-1Router# copy tftpxcpa28-6 slot0xcpa28-6 Using Flash MemoryRouter# squeeze slot0 Using Additional Flash Memory CommandsRouter# cd slot0 Tftpxcpa27-1 disk0xcpa27-1 Using SanDisk DevicesRecovering from Locked Blocks Router# configuration term Running HP Escon PA Diagnostic TestsConfiguring the HP Escon PA