Cisco Systems PA-4C-E 1 manual Step

Removing and Installing Port Adapters

Cisco 7200 Series Routers and Cisco 7200 VXR Routers—Removing and Installing a Port Adapter

Step 1

To remove the port adapter, place the port adapter lever in the unlocked position. (See A.) The port adapter lever remains in the unlocked position.

Step 2

Grasp the handle of the port adapter and pull the port adapter from the router, about halfway out of its slot. If you are removing a blank port adapter, pull the blank port adapter completely out of the chassis slot.

Step 3

With the port adapter halfway out of the slot, disconnect all cables from the port adapter. After disconnecting the cables, pull the port adapter from its chassis slot.

Step 4

To insert the port adapter, carefully align the port adapter carrier between the upper and the lower edges of the port adapter slot. (See B.)

Step 5

Carefully slide the new port adapter halfway into the port adapter slot. (See B.)

Step 6

With the port adapter halfway into the slot, connect all required cables to the port adapter. After connecting all required cables, carefully slide the port adapter all the way into the slot until the port adapter is seated in the router midplane.

Step 7

After the port adapter is properly seated, lock the port adapter lever. (See A.)

Port adapter lever (locked position)

		6
	5
		FAST ETHERNET
		ETHERNET 10BT
A		4
	3
		0
		FAST SERIAL
		2
	1
	Cisco 7200	FAST ETHERNET INPUT/OUTPUT CONTROLLER
	Series	0
Note: This adapter		Port adapter lever
removal applies to any
port or service adapter.		(unlocked position)

Slot		TOKEN RING
		6
guide	5
	3	4
		FAST ETHERNET
		ETHERNET 10BT
		0
	1
	Cisco 7200
	Series	27996
	B

PA-4C-E 1-Port High-Performance ESCON Channel Port Adapter Installation and Configuration

24 OL-3743-02