Cisco Systems PA-2H manual Ff Ff Ff Ff Ff Ff Ff Ff

Page 57

Checking the Configuration

Bridging software.

X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.

Chassis Interface.

1 VIP2 controllers (2 HSSI).

2 HSSI network interfaces.

125K bytes of non-volatile configuration memory.

20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K). 8192K bytes of Flash internal SIMM (Sector size 256K). Configuration register is 0x2

Use the show diag slot command to determine which type of port adapter is installed on a VIP2 in your system. Speciﬁc port adapter information is displayed, as shown in the following example. Two HSSI port adapters are in port adapter slots (bays) 0 and 1, on a VIP2 in interface processor slot 1:

Router# show		diag	1
Slot 2:
HSSI-B port adapter, 1					port
Port adapter		is analyzed
Port adapter		insertion time 2d13h ago
Hardware revision			1.17				Board revision			A0
Serial number			4518292				Part number			73-1801-05
Test history			0x0				RMA number			00-00-00
EEPROM format version 1
EEPROM contents (hex):
0x20:01	74 01	11	00	44	F1	94	49 07 09 05	00	00	00 00
0x30:50 00 00 00 97				04	21	00 FF FF FF FF FF FF FF FF
	Slot	database information:
	Flags: 0x4				Insertion time: 0x14E8 (3d00h ago)

VIP Controller Memory Size: Unknown

PA Bay 0 Information:

HSSI-B PA, 1 ports

EEPROM format version 1

HW rev 1.1, Board revision A0

Serial number: 04551053 Part number: 73-1801-05

PA Bay 1 Information:

HSSI-B PA, 1 ports

EEPROM format version 1

HW rev 1.1, Board revision A0

Serial number: 04518147 Part number: 73-1801-05

Cable Installation and Interface Configuration 7-13

Image 57

Contents Corporate Headquarters Copyright 1996-1999, Cisco Systems, Inc All rights reserved About This Manual Document ObjectivesDocument Organization Cisco Connection Online Cisco Connection OnlineIf You Need More Information Documentation CD-ROMIf You Need More Information If You Need More Information If You Need More Information Port Adapter Overview Overview605559 LEDs Hssi Interface Cable Receptacles, Cables, and PinoutsHssi Null Modem Cable Null Modem Cable ConnectorsReceptacles, Cables, and Pinouts List of Parts and Tools Preparing for InstallationPlatform Minimum Cisco IOS Release Software and Hardware RequirementsSafety Warnings Safety GuidelinesSafety Guidelines Telephone Wiring Guidelines Electrical Equipment GuidelinesPreventing Electrostatic Discharge Damage FCC Class B Compliance VIP2 and the Dual-Port Hssi Port Adapter Installation OverviewVIP2-50 with Two Hssi Port Adapters in Port Adapter Slots 0 Location of Port Adapter Screw Partial Port Adapter View Removing a Port AdapterInstalling a New Port Adapter Installing a Port AdapterInstalling a Port Adapter Installation Overview Catalyst RSM/VIP2 and the Dual-Port Hssi Port Adapter Catalyst RSM/VIP2-40 with PA-2H in Port Adapter Slot Removing a Port Adapter Installing a Port Adapter Installing a New Port Adapter Installation Overview Cisco 7206 with an Hssi Port Adapter in Port Adapter Slot Cisco 7200 Series and the Dual-Port Hssi Port AdapterPort adapter Handle Lever unlocked Position Handling a Port Adapter Replacing a Port AdapterSlot Port adapter Installation Overview Cisco uBR7200 Series Dual-Port Hssi Port Adapter Port adapters Port adapters Port adapter lever in unlocked position Inside slot guide PC board Metal carrier Port adapter retention clip in locked position Installation Overview Attaching Hssi Port Adapter Interface Cables Cable Installation and Interface ConfigurationAttaching a Null Modem Cable Connecting Hssi Cables Front View-PA-2H Shown without HandleConﬁguring the Hssi Interfaces Cisco 7200 Series and Cisco uBR7200 Series Ports Cisco 7206 Hssi Port Number Example VIP2 Ports Conﬁguring InterfacesConfiguring Interfaces Checking the Conﬁguration Conﬁguring Cyclic Redundancy ChecksUsing show Commands to Verify the New Interface Status Cisco 7200 Series and Cisco uBR7200 Series show Commands Use the show diag command to display the hardware revision VIP2 show Commands FF FF FF FF FF FF FF FF Catalyst RSM/VIP2 show Commands Router# show version FF FF FF FF FF FF FF FF Router# ping Using the ping CommandConfiguring the Hssi Interfaces