Cisco Systems Media Gateway Controller Node Manager Task 10 Install the CiscoView Security Module

Chapter 2 Installing Cisco MNM

Performing a New Installation of Cisco MNM

Cisco MNM finds the new elements using the appropriate SSH protocol. Non-SNMP communication with elements now uses SSH secure utilities.

Identifying SSH-Enabled Elements

You can find out if an element uses SSH by checking the Security Policy in the Accounts dialog box.

Task 10: Install the CiscoView Security Module

If you are using CiscoView, you must install the CiscoView Security Module on the CiscoView server after CiscoView and Cisco MNM have been installed.

Step 1 Find the IP address that Cisco MNM is using for the CiscoView server.

For example, if Cisco EMF is installed in <CEMF_ROOT>, enter

%<CEMF_ROOT>/bin/cmnmupdateCVip -showip

Note An IP address of 0.0.0.0 is the local workstation.

If the address is not correct, see the “Changing the IP Address of the CiscoView Server If Needed” section on page 2-17 for instructions.

Step 2 Locate the CSCOcvsec.pkg that is shipped with the Cisco MNM software that resides in the following ciscoviewsecurity directory:

#cd ciscoviewsecurity

If the CiscoView server is not installed on the Cisco EMF server, go to Step 3. If the CiscoView server is installed on the Cisco EMF server, go to Step 5.

Step 3 Use ftp to copy the CSCOcvsec package to the CiscoView server using the CiscoView server IP address you determined with the cmnmupdateCVip command:

%ftp cvserverIPAddress ftp> cd /tmp

ftp> binary

ftp> put CSCOcvsec.pkg /tmp/CSCOcvsec.pkg

Step 4 Use Telnet (or SSH) to connect to the CiscoView server using the following command:

#telnet cvserver

Step 5 Change the user to root.

%su - root

Step 6 Install the package using the following command:

#/usr/sbin/pkgadd -d /tmp/CSCOcvsec.pkg

Note If you uninstall and reinstall Cisco MNM, you must reinstall the security package.

	Cisco Media Gateway Controller Node Manager Installation Guide
OL-18332-01		2-19