![](/images/new-backgrounds/1172969/172969163x1.webp)
Appendix B Replacing the Power Supply
Replacing the Chassis Cover
Figure B-14 Replacing the Chassis Cover
Chassis cover
35662
Front panel
Chassis bottom
Step 3 Lower the front of the top cover to close the chassis, and ensure the following:
•The chassis cover tabs fit under the edge of the chassis rear panel so that they are not exposed.
•The chassis tabs fit under the chassis cover so that they are not exposed.
•The chassis cover side tabs on both sides fit inside the chassis side panels so that they are not exposed.
When the chassis cover is properly assembled, no tabs are visible.
Step 4 | Secure the chassis cover with five screws. | |||
Step 5 | If you installed a different type of power supply (AC or DC) than was originally installed in the universal | |||
| gateway, place one of the power ratings labels that came in the plastic bag with the documentation | |||
| directly over the power ratings information on the rear panel. For example, if the original chassis came | |||
| with an AC power supply and you replaced it with a DC power supply, place the DC power ratings label | |||
| over the ratings stamped on the rear panel of the chassis. This will ensure that the correct power ratings | |||
| information appears on the rear panel. (See Figure | |||
| Figure | Power Ratings Label for DC Power Supply | ||
|
|
|
| |
| INPUT | 150VA |
| |
|
|
|
| |
| Figure | Power Ratings Label for AC Power Supply | ||
|
|
| ||
| INPUT 100 – 240V~ 50/60Hz | 2 – 1A |
| |
|
|
|
|
|
| Figure |
|
|
|
Step 6 | Reinstall the chassis on a rack, desktop, or table. | |||
Step 7 | Reinstall all interface cables. |
|
|
Cisco AS5350XM Universal Gateway Chassis Installation Guide
|
|
| |
|
|