Chapter 4 Configuring with the Command-Line Interface
Verifying the Configuration
standby use-interface Loopback102 revertive standby use-interface Multilink2 backhaul
!
controller T1 0/0 framing esf cablelength short 133ft clock source internal linecode b8zs
channel-group 0 timeslots 1-1 speed 64 channel-group 1 timeslots 2-24 speed 64
!
controller T1 0/1 framing esf
clock source internal linecode b8zs cablelength short 133ft
!
!
class-map match-all class1_fch match ip dscp cs5
class-map match-all class2_sch match ip dscp cs4
class-map match-any class3_paging_ospf match ip dscp cs3
match access-group 101
!
policy-map llq-policy class class1_fch
priority percent 68 class class2_sch
bandwidth percent 20 queue-limit 128
class class3_paging_ospf bandwidth percent 2 queue-limit 128
class class-default queue-limit 512
!
ip dhcp excluded-address 192.168.146.1 192.168.146.3 ip dhcp ping packets 0
!
ip dhcp pool pbts
network 192.168.146.0 255.255.255.0 bootfile CENOMIbts.img next-server OMCR-IPaddr
option 43 ascii "Logical-IPaddr CENOMI-IPaddr another-IPaddr SpanMapping" default-router 192.168.146.3
dns-serverOMCR-IPaddr lease 0 0 1
!
ip routing
ip subnet-zero ip classless
ip multicast-routing
ip tftp source-interface Loopback 0 cdp run
!
!Setup sys logging to OMCIP-CW2000
logging on
logging buffered 4 logging cw4mw logging trap 5
logging source-interface Loopback0
Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide
