Cisco Systems 78-13983-04 manual Configuring with the Command-Line Interface

C H A P T E R 4

Configuring with the Command-Line Interface

This chapter describes how to use the Cisco IOS software command-line interface (CLI) to configure the following features of the MWR 1900:

•Before You Begin, page 4-2

•Verifying the Version of Cisco IOS Software, page 4-2

•Configuring the Host Name and Password, page 4-2

•Configuring Multilink Interfaces, page 4-7

•Configuring Fast Ethernet Interfaces, page 4-4

•Configuring Multilink Interfaces, page 4-7

•Configuring T1 and E1 Interfaces, page 4-11

•Configuring QoS Attributes, page 4-13

•Configuring Redundancy, page 4-16

•Saving Configuration Changes, page 4-18

•Verifying the Configuration, page 4-18

•Monitoring and Managing the MWR 1900, page 4-22

•Where to Go Next, page 4-24

Follow the procedures in this chapter to configure the router manually or if you want to change the configuration after you have run the setup command facility (described in Chapter 1, “First-Time Configuration”).

This chapter describes how to configure features related to the use of the MWR 1900 in an IP-RAN. For additional configuration topics, refer to the Cisco IOS configuration guide and command reference publications. These publications are available on the Documentation CD-ROM that came with your router, on the World Wide Web from Cisco’s home page, or you can order printed copies separately.

Note If you skipped the previous chapter, Chapter 3, “Cisco IOS Software Basics,” and you have never configured a Cisco router, go back to that chapter and read it now. The chapter contains important information you need to successfully configure your router.

Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide

78-13983-04 4-1