Cisco Systems 78-13983-04 Monitoring and Managing the MWR, Exit interface configuration mode

Chapter 4 Configuring with the Command-Line Interface

Monitoring and Managing the MWR 1900

network 192.168.146.0 0.0.0.255 area 51 network 192.168.147.0 0.0.0.255 area 51 network 10.0.0.0 0.255.255.255 area 51

default-information originate metric 100 metric-type 1 distribute-list 11 out

distance 120

!

ip route 64.102.16.25 255.255.255.255 FastEthernet0/0 ip route 64.102.16.25 255.255.255.255 192.168.1.10

!

Notes

•Keepalives must be set for all Ethernet interfaces to ensure proper redundant behavior. A keepalive value of 1 has been selected for maximum responsiveness.

•Configuring no ip proxy-arpis helpful to avoid confusion with routes and ARP caches.

•In a redundant configuration, both MWR 1900s share a common IP address for their Multilink interface.

Monitoring and Managing the MWR 1900

You can use Cisco’s network management applications, such as CiscoWorks2000 for Mobile Wireless (CW4MW), to monitor and manage aspects of the MWR 1900.

To enable remote network management of the MWR 1900, do the following:

Step 1 At the privileged prompt, enter the following command to access configuration mode:

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#

Step 2 At the configuration prompt, enter the following command to assign a host name to each of the network management workstations:

Router(config)# ip host hostname ip_address

Where hostname is the name assigned to the Operations and Maintenance (O&M) workstation and ip_address is the address of the network management workstation.

Step 3 Enter the following commands to create a loopback interface for O&M:

Router(config)# interface loopback number

Router(config-if)#ip address ip_address subnet_mask

Step 4 Exit interface configuration mode:

Router(config-if)# exit

Step 5 At the configuration prompt, enter the following command to specify the recipient of a Simple Network Management Protocol (SNMP) notification operation:

Router(config)# snmp-server host hostname [traps informs] [version {1 2c 3 [auth noauth priv]}] community-string[udp-port port] [notification-type]

Where hostname is the name assigned to the CW4MW workstation with the ip host command in Step 2.

Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide

4-22 78-13983-04