Cisco Systems 78-13983-04 Ppp mux subframe count, Default maximum is Interface configuration

Chapter 5 Command Reference

ppp mux subframe count

ppp mux subframe count

To set the maximum number of PPP subframes that can be contained in a superframe, use the ppp mux subframe count command in interface configuration mode. To set the maximum number to the default, use the no form of this command.

ppp mux subframe count integer

no ppp mux subframe count

Syntax Description	integer	The maximum number of subframes that can be contained in a superframe.
		Possible values are 1 through 15 bytes.

Defaults

Command Modes

Command History

The default maximum is 15.

Interface configuration

ReleaseModification

12.2(8)MC2 This command was introduced.

Usage Guidelines

Examples

Related Commands

To use this command, you must first enable PPP multiplexing/demultiplexing.

The following example sets the maximum subframe count to 20 bytes.

ppp mux subframe count 20

Command	Description
ppp mux	Enables PPP multiplexing/demultiplexing
ppp mux delay	Sets the maximum delay.
ppp mux frame	Sets the maximum length of the PPP superframe.
ppp mux pid	Sets the default PPP protocol ID.
ppp mux subframe length Sets the maximum length of the PPP subframe.
show ppp mux	Displays PPP mux counters for the specified multilink interface.

Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide

78-13983-04 5-13