Cisco Systems 7600 Configuring the Gigabit Ethernet Interfaces, Configuring the POS Interfaces

Page 10

Chapter 2 Basic MSFC Software Configuration

Configuring the MSFC2

These sections describe how to configure the Layer 3 interfaces on the modules installed in the Cisco 7600 OSR:

•Configuring the Gigabit Ethernet Interfaces, page 2-10

•Configuring the POS Interfaces, page 2-10

•Configuring the ATM Interfaces, page 2-11

•Verifying and Saving the Layer 3 Interface Configuration, page 2-11

Configuring the Gigabit Ethernet Interfaces

The Layer 3 Gigabit Ethernet module WAN interfaces enable connections to external Gigabit Ethernet networks.

This example shows a configuration dialog for a four-port GE WAN Gigabit Interface Converter (GBIC) module. You should respond to the queries according to your configuration requirements. Use your IP address and subnet mask in responding to the setup prompts.

Configuring interface GigabitEthernet3/0:

Is this interface in use?: yes

Configure IP on this interface?: yes

Configure IP unnumbered on this interface?: no

IP address for this interface: 2.2.1.1

Number of bits in subnet field: 0

Class A network is 2.0.0.0, 0 subnet bits; mask is 255.0.0.0

Configure CLNS on this interface?: yes

For complete Gigabit Ethernet interface configuration information, refer to the Cisco 7600 Optical Services Router Software Configuration Guide.

Configuring the POS Interfaces

The POS module interfaces enable connections to external OC-3/STM-1 or

OC-12/STM-4 networks.

This example shows a configuration dialog for an OC-3c POS module. You should respond to the queries according to your configuration requirements. Use your IP address and subnet mask when responding to the setup prompts.

Configuring interface POS4/0:

Is this interface in use?: yes

Configure IP on this interface?: yes

Configure IP unnumbered on this interface?: no

 

Cisco 7600 Optical Services Router Quick Software Configuration Guide

2-10

78-12799-01

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Configuring the MSFC2 This chapter contains these sectionsConsole session Using the setup Facility or the setup Command That you have successfully booted the system Configuring Global ParametersBoot the system to display the user Exec prompt Router StepsBasic Msfc Software Configuration Configuring the MSFC2 Enter the enable secret password when prompted to do so This display shows that no interfaces have been configuredFor future use, make a note of this password Enter the enable password when prompted to do so Sample Display of Global Parameters Specify the Igrp autonomous system number as followsConfiguring Network Interfaces Configuring the Gigabit Ethernet Interfaces Configuring the POS InterfacesConfiguring the ATM Interfaces Verifying and Saving the Layer 3 Interface ConfigurationRouter Router# show version Using the Global Configuration Mode Verifying the Running Configuration Settings Router# show running-configHostname Router No service pad An OC-12 ATM interface installed in slot Saving the Running Configuration Settings to Nvram Reviewing the Running Configuration SettingsDisplays the following output Aal5mux ip 155000 155000 Performing Other Configuration Tasks Configuring the Software Configuration Register Configuring Boot Field Settings and Using the Boot Command Changing the Software Configuration Register Settings Routerconfig# config-register 0xvalueRouterconfig# end Router# Privileged Exec mode Recovering a Lost PasswordThis section tells you how to recover a lost password To recover a lost password, perform these stepsPress Return Reboot the router and enable it using the recovered password
Related manuals
Manual 12 pages 20.11 Kb Manual 70 pages 32.94 Kb Manual 20 pages 62.17 Kb Manual 10 pages 7.94 Kb
Top Page Image Contents