Cisco Systems 7600 manual Hostname Router

Page 16

Chapter 2 Basic MSFC Software Configuration

Verifying the Running Configuration Settings

version 12.1 no service pad

service timestamps debug uptime service timestamps log uptime no service password-encryption

!

hostname Router

!

!

interface GigabitEthernet5/1 no ip address

shutdown

no negotiation auto no cdp enable

!

interface GigabitEthernet5/2

description b2b connection to osr1(g7/2) ip address 1.5.0.2 255.255.0.0

no keepalive

no negotiation auto no cdp enable

!

!

line con 0 exec-timeout 0 0 transport input none line vty 0 4

login

!

end

Router#

Example of Running Configuration Settings for an OC-3 POS Interface

The show running-configcommand typically displays the following output for an OC-3c/STM-1c POS interface installed in slot 7:

Router# show running-config

Building configuration...

Current configuration:

!

version 12.1

	Cisco 7600 Optical Services Router Quick Software Configuration Guide
2-16	78-12799-01

Image 16

Contents Configuring the MSFC2 This chapter contains these sectionsConsole session Using the setup Facility or the setup Command Configuring Global Parameters Boot the system to display the user Exec prompt RouterThat you have successfully booted the system StepsBasic Msfc Software Configuration Configuring the MSFC2 Enter the enable secret password when prompted to do so This display shows that no interfaces have been configuredFor future use, make a note of this password Enter the enable password when prompted to do so Sample Display of Global Parameters Specify the Igrp autonomous system number as followsConfiguring Network Interfaces Configuring the Gigabit Ethernet Interfaces Configuring the POS InterfacesConfiguring the ATM Interfaces Verifying and Saving the Layer 3 Interface ConfigurationRouter Router# show version Using the Global Configuration Mode Verifying the Running Configuration Settings Router# show running-configHostname Router No service pad An OC-12 ATM interface installed in slot Saving the Running Configuration Settings to Nvram Reviewing the Running Configuration SettingsDisplays the following output Aal5mux ip 155000 155000 Performing Other Configuration Tasks Configuring the Software Configuration Register Configuring Boot Field Settings and Using the Boot Command Changing the Software Configuration Register Settings Routerconfig# config-register 0xvalueRouterconfig# end Router# Recovering a Lost Password This section tells you how to recover a lost passwordPrivileged Exec mode To recover a lost password, perform these stepsPress Return Reboot the router and enable it using the recovered password

Related manuals

Manual 12 pages 20.11 Kb

Manual 70 pages 32.94 Kb

Manual 20 pages 62.17 Kb

Manual 10 pages 7.94 Kb