Cisco Systems 7600 manual Performing Other Configuration Tasks

Page 21

Chapter 2 Basic MSFC Software Configuration

Performing Other Configuration Tasks

no ip classless

ip route 2.5.4.254 255.255.255.255 Ethernet0

!

map-list atm1

ip 1.1.1.1 atm-vc 1 ip 1.1.1.3 atm-vc 2 ip 1.1.1.4 atm-vc 4 ip 15.0.0.1 atm-vc 3 ip 15.0.0.5 atm-vc 10 ip 15.0.0.6 atm-vc 11 no logging trap

!

!

line con 0 exec-timeout 0 0 line aux 0

line vty 0 4 password bambam login

!

end

Performing Other Configuration Tasks

This section describes the procedures for performing these additional configuration tasks:

•Configuring the Software Configuration Register, page 2-22

•Recovering a Lost Password, page 2-26

 

 

Cisco 7600 Optical Services Router Quick Software Configuration Guide

 

 

 

 

 

 

78-12799-01

 

 

2-21

 

 

 

Page 20 Page 22
Image 21
Page 20 Page 22
Contents This chapter contains these sections Configuring the MSFC2Console session Using the setup Facility or the setup Command Boot the system to display the user Exec prompt Router Configuring Global ParametersThat you have successfully booted the system StepsBasic Msfc Software Configuration Configuring the MSFC2 This display shows that no interfaces have been configured Enter the enable secret password when prompted to do soFor future use, make a note of this password Enter the enable password when prompted to do so Specify the Igrp autonomous system number as follows Sample Display of Global ParametersConfiguring Network Interfaces Configuring the POS Interfaces Configuring the Gigabit Ethernet InterfacesVerifying and Saving the Layer 3 Interface Configuration Configuring the ATM InterfacesRouter Router# show version Using the Global Configuration Mode Router# show running-config Verifying the Running Configuration SettingsHostname Router No service pad An OC-12 ATM interface installed in slot Reviewing the Running Configuration Settings Saving the Running Configuration Settings to NvramDisplays the following output Aal5mux ip 155000 155000 Performing Other Configuration Tasks Configuring the Software Configuration Register Configuring Boot Field Settings and Using the Boot Command Routerconfig# config-register 0xvalue Changing the Software Configuration Register SettingsRouterconfig# end Router# This section tells you how to recover a lost password Recovering a Lost PasswordPrivileged Exec mode To recover a lost password, perform these stepsPress Return Reboot the router and enable it using the recovered password
Related manuals
Manual 12 pages 20.11 Kb Manual 70 pages 32.94 Kb Manual 20 pages 62.17 Kb Manual 10 pages 7.94 Kb
Top Page Image Contents