Cisco Systems 7600 manual Router# show version

Page 13

Chapter 2 Basic MSFC Software Configuration

Configuring the MSFC2

When you enter the show version command, the following typical display appears:

Router# show version

Cisco Internetwork Operating System Software

IOS (tm) MSFC2 Software (C6MSFC2-JSV-M), Version 12.1(5b)E7, EARLY

DEPLOYMENT RELEASE SOFTWARE (fc1)

TAC Support:http://www.cisco.com/cgi-bin/ibld/view.pl?i=support

Copyright (c) 1986-2001 by cisco Systems, Inc.

Compiled Fri 09-Feb-01 19:28 by hqluong

Image text-base:0x30008980, data-base:0x3177A000

ROM:System Bootstrap, Version 12.1(3r)E2, RELEASE SOFTWARE (fc1) BOOTFLASH:MSFC2 Software (C6MSFC2-BOOT-M), Version 12.1(5b)E7, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

cat6k-msfc uptime is 3 minutes System returned to ROM by power-on Running default software

cisco Cat6k-MSFC2 (R7000) processor with 491520K/32768K bytes of memory.

Processor board ID SAD044407E3

R7000 CPU at 300Mhz, Implementation 39, Rev 2.1, 256KB L2, 1024KB L3 Cache

Last reset from power-on Bridging software.

X.25 software, Version 3.0.0.

SuperLAT software (copyright 1990 by Meridian Technology Corp). TN3270 Emulation software.

1 POS controller (4 POS).

1 Virtual Ethernet/IEEE 802.3 interface(s)

4 Packet over SONET network interface(s)

509K bytes of non-volatile configuration memory.

16384K bytes of Flash internal SIMM (Sector size 512K). Configuration register is 0x2102

Router#

		Cisco 7600 Optical Services Router Quick Software Configuration Guide

	78-12799-01			2-13
	78-12799-01			2-13

Image 13

Contents This chapter contains these sections Configuring the MSFC2Console session Using the setup Facility or the setup Command Boot the system to display the user Exec prompt Router Configuring Global ParametersThat you have successfully booted the system StepsBasic Msfc Software Configuration Configuring the MSFC2 Enter the enable secret password when prompted to do so This display shows that no interfaces have been configuredFor future use, make a note of this password Enter the enable password when prompted to do so Specify the Igrp autonomous system number as follows Sample Display of Global ParametersConfiguring Network Interfaces Configuring the POS Interfaces Configuring the Gigabit Ethernet InterfacesVerifying and Saving the Layer 3 Interface Configuration Configuring the ATM InterfacesRouter Router# show version Using the Global Configuration Mode Router# show running-config Verifying the Running Configuration SettingsHostname Router No service pad An OC-12 ATM interface installed in slot Saving the Running Configuration Settings to Nvram Reviewing the Running Configuration SettingsDisplays the following output Aal5mux ip 155000 155000 Performing Other Configuration Tasks Configuring the Software Configuration Register Configuring Boot Field Settings and Using the Boot Command Routerconfig# config-register 0xvalue Changing the Software Configuration Register SettingsRouterconfig# end Router# This section tells you how to recover a lost password Recovering a Lost PasswordPrivileged Exec mode To recover a lost password, perform these stepsPress Return Reboot the router and enable it using the recovered password

Related manuals

Manual 12 pages 20.11 Kb

Manual 70 pages 32.94 Kb

Manual 20 pages 62.17 Kb

Manual 10 pages 7.94 Kb