Cisco Systems 7600 Verifying the Running Configuration Settings, Router# show running-config

Page 15

Chapter 2 Basic MSFC Software Configuration

Verifying the Running Configuration Settings

Step 4 Save your configuration settings, as described in the “Saving the Running Configuration Settings to NVRAM” section on page 2-19 .

Your router is now minimally configured and able to boot using the currently established configuration information.

To display a list of the configuration commands available to you, enter a question mark (?) at the global configuration mode prompt (Router (config)#).

Verifying the Running Configuration Settings

You may want to verify the running configuration settings or any changes made to the running configuration settings before they are saved. To do so, enter the show running-configcommand at the privileged EXEC mode prompt.

Typical output from this command is shown in the following sections:

•Example of Running Configuration Settings for a Gigabit Ethernet WAN Interface, page 2-15

•Example of Running Configuration Settings for an OC-3 POS Interface, page 2-16

•Example of Running Configuration Settings for OC-12 POS Interface, page 2-17

•Example of Running Configuration Settings for OC-12 ATM Interface, page 2-18

Example of Running Configuration Settings for a Gigabit Ethernet WAN Interface

The show running-configcommand typically displays the following output for an OC-3c/STM-1c POS interface installed in slot 7:

Router# show running-config

Building configuration...

Current configuration :2381 bytes

!

		Cisco 7600 Optical Services Router Quick Software Configuration Guide

	78-12799-01			2-15
	78-12799-01			2-15

Image 15

Contents This chapter contains these sections Configuring the MSFC2Console session Using the setup Facility or the setup Command Steps Configuring Global ParametersBoot the system to display the user Exec prompt Router That you have successfully booted the systemBasic Msfc Software Configuration Configuring the MSFC2 This display shows that no interfaces have been configured Enter the enable secret password when prompted to do soFor future use, make a note of this password Enter the enable password when prompted to do so Specify the Igrp autonomous system number as follows Sample Display of Global ParametersConfiguring Network Interfaces Configuring the POS Interfaces Configuring the Gigabit Ethernet InterfacesVerifying and Saving the Layer 3 Interface Configuration Configuring the ATM InterfacesRouter Router# show version Using the Global Configuration Mode Router# show running-config Verifying the Running Configuration SettingsHostname Router No service pad An OC-12 ATM interface installed in slot Reviewing the Running Configuration Settings Saving the Running Configuration Settings to NvramDisplays the following output Aal5mux ip 155000 155000 Performing Other Configuration Tasks Configuring the Software Configuration Register Configuring Boot Field Settings and Using the Boot Command Routerconfig# config-register 0xvalue Changing the Software Configuration Register SettingsRouterconfig# end Router# To recover a lost password, perform these steps Recovering a Lost PasswordThis section tells you how to recover a lost password Privileged Exec modePress Return Reboot the router and enable it using the recovered password

Related manuals

Manual 12 pages 20.11 Kb

Manual 70 pages 32.94 Kb

Manual 20 pages 62.17 Kb

Manual 10 pages 7.94 Kb