Cisco Systems 7600 manual No service pad

Page 17

Chapter 2 Basic MSFC Software Configuration

Verifying the Running Configuration Settings

no service pad

no service udp-small-servers no service tcp-small-servers

!

hostname Router

!

enable secret 5 $1$W6K5$W/p5Bq6IPLGJ/hS9VVP1g. enable password lab

interface POS7/0

ip address 11.1.1.1 255.255.255.0 crc 32

clock source internal

!

interface POS7/1 no ip address

no ip route-cache cef no ip route-cache shutdown

crc 32

!

interface POS7/2 no ip address

no ip route-cache cef no ip route-cache shutdown

crc 32

!

interface POS7/3 no ip address

no ip route-cache cef no ip route-cache shutdown

crc 32

!

Example of Running Configuration Settings for OC-12 POS Interface

The show running-configcommand typically displays the following output for an OC-12 POS interface installed in slot 6:

Router# show running-config

Building configuration...

Current configuration:

		Cisco 7600 Optical Services Router Quick Software Configuration Guide

	78-12799-01			2-17
	78-12799-01			2-17

Image 17

Contents This chapter contains these sections Configuring the MSFC2Console session Using the setup Facility or the setup Command Boot the system to display the user Exec prompt Router Configuring Global ParametersThat you have successfully booted the system StepsBasic Msfc Software Configuration Configuring the MSFC2 For future use, make a note of this password This display shows that no interfaces have been configuredEnter the enable secret password when prompted to do so Enter the enable password when prompted to do so Specify the Igrp autonomous system number as follows Sample Display of Global ParametersConfiguring Network Interfaces Configuring the POS Interfaces Configuring the Gigabit Ethernet InterfacesVerifying and Saving the Layer 3 Interface Configuration Configuring the ATM InterfacesRouter Router# show version Using the Global Configuration Mode Router# show running-config Verifying the Running Configuration SettingsHostname Router No service pad An OC-12 ATM interface installed in slot Displays the following output Reviewing the Running Configuration SettingsSaving the Running Configuration Settings to Nvram Aal5mux ip 155000 155000 Performing Other Configuration Tasks Configuring the Software Configuration Register Configuring Boot Field Settings and Using the Boot Command Routerconfig# config-register 0xvalue Changing the Software Configuration Register SettingsRouterconfig# end Router# This section tells you how to recover a lost password Recovering a Lost PasswordPrivileged Exec mode To recover a lost password, perform these stepsPress Return Reboot the router and enable it using the recovered password

Related manuals

Manual 12 pages 20.11 Kb

Manual 70 pages 32.94 Kb

Manual 20 pages 62.17 Kb

Manual 10 pages 7.94 Kb