Configuring Network Interfaces

Chapter 2 Basic MSFC Software Configuration

Configuring the MSFC2

Configuring global parameters:

Enter host name: Router

Enter enable secret: barney

Enter enable password: wilma

Enter virtual terminal password: bambam

Configure IP?: yes

Configure IGRP routing?: yes

Your IGRP autonomous system number [1]: 199

Configure SNMP Network Management?: yes

Community string [public]:

Configure CLNS? [no]: yes

CLNS router tag [area_1]:

CLNS domain [49]:

CLNS area [0001]:

CLNS station id [0027.25E9.B640]:

This section contains the procedures for configuring the Layer 3 network interfaces for the modules installed in the Cisco 7600 OSR by using the setup facility or the setup command. After the interfaces are configured, the Cisco 7600 OSR can communicate with external networks.

To configure the Layer 3 interface parameters for the Cisco 7600 OSR, you need this information:

•Interface network addresses

•Subnet masks

•Protocols to be configured

For additional Layer 3 interface configuration information for each of the modules installed in your Cisco 7600 OSR, refer to the Cisco 7600 Optical Services Router Software Configuration Guide.

Note The sample configuration dialog in this section continues the script displayed when you used the setup facility or the setup command in establishing the system global parameters (see the “Configuring Global Parameters” section on page 2-4). The output shown in this section is only an example; your configuration dialog might be different, depending on how you configure your router.

	Cisco 7600 Optical Services Router Quick Software Configuration Guide

78-12799-01		2-9
78-12799-01		2-9