Cisco Systems 7600 manual Sample Display of Global Parameters

Chapter 2 Basic MSFC Software Configuration

Configuring the MSFC2

Specify the IGRP autonomous system number as follows:

Configure IP? [yes]: yes

Configure IGRP routing? [yes]: yes

Your IGRP autonomous system number [1]: 199

Step 8 Enter yes or no to the following query to accept or refuse Simple Network Management Protocol (SNMP) management:

Configure SNMP Network Management? [yes]:

Community string [public]:

Note SNMP is the most widely supported standard for managing networks. SNMP provides a means to access and set configuration and run-time parameters and to monitor and control network elements for routers and communication servers.

Step 9 Enter yes or no to the following query to accept or refuse Connectionless Network Service (CLNS) management:

Configure CLNS? [no]: yes

CLNS router tag [area_1]:

CLNS domain [49]:

CLNS area [0001]:

CLNS station id [0027.25E9.B640]:

Note CLNS is an Open System Interconnection (OSI) layer service that does not require a circuit to be established before transmitting data.

On completion of this procedure, you have successfully established the router’s global configuration parameters.

Sample Display of Global Parameters

The following sample display lists the global parameters that you entered in

Step 3 through Step 10 in the preceding section.

The display indicates the order in which the parameters and their defaults appear on your console terminal.

	Cisco 7600 Optical Services Router Quick Software Configuration Guide
2-8	78-12799-01