Cisco Systems manual Configuring the Cisco 700 Router as an Rcapi Server, Rcapi Command Summary

Configuring the Cisco 700 Router as an RCAPI Server

Configuring the Cisco 700 Router as an RCAPI Server

This section describes how to configure the Cisco 700 series router to be an RCAPI server.

By default, RCAPI is disabled in the router. Enabling RCAPI causes the router to become an RCAPI server. When RCAPI is enabled, the router listens for incoming RCAPI messages from PCs connected on its LAN side. By default, the router listens for RCAPI messages on TCP port 2578.

Figure 6-1 illustrates the configuration used in this example. The PCs in the figure have RVS-COM software installed.

Figure 6-1	RCAPI Server Configuration Example
Local PC	Local 7xx	Remote 7xx	Remote PC
	router	router

IP address	IP address	IP address
192.168.2.2	192.168.2.1	192.168.3.1
	Directory numbers	Directory numbers
	5554000/5552000	5553000/551000

IP address 192.168.3.2

26547

RCAPI Command Summary

Following is the command summary for configuring the RCAPI on the local Cisco 700 series router.

set rcapi on

set dir 5554000

set rcapi 1 number 5554000 set rcapi server port 2578

reboot

6-4Cisco700 Series Router Configuration Guide