Chapter 3 T1 and E1 Feature Cards
Configuring Input Impedance for the E1 Feature Card
Note For information about configuring the T1 or E1 ports, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide.
Configuring Input Impedance for the E1 Feature Card
You can set the input impedance of the E1 feature card before or after running the setup script. For information on configuring the universal gateway with the setup script, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide.
Configuration
| To set the input impedance for the E1 feature card, use the | |
|
|
|
| Command | Purpose |
Step 1 |
|
|
Router> enable | Enters enable mode. | |
| Password: password | Enter the password. You have entered enable mode when |
| Router# | |
|
| the prompt changes to Router#. |
Step 2 |
|
|
Router# configure terminal | Enters global configuration mode. You have entered | |
| Enter configuration commands, one per line. End | global configuration mode when the prompt changes to |
| with CNTL/Z. | Router(config)#. |
| Router(config)# | |
|
| |
Step 3 |
|
|
Router(config)# controller e1 0 | Enter the controller number on which you are configuring | |
| input impedance. | |
Step 4 |
|
|
Sets the input impedance to 75 ohm for the controller. | ||
| The | |
|
| Step 4 for the other controllers. |
Step 5 |
|
|
Returns to enable mode. | ||
| Router# | This message is normal and does not indicate an error. |
| ||
| console |
|
|
|
|
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
|
|
| |
|
|