
Chapter 6 Voice Feature Card
Online Insertion and Removal of the Voice Feature Card
OIR events:
Number of insertions = 0, Number of removals = 1
DFC State is DFC_S_REMOVED
Installing the Voice Feature Card
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Note When you replace a feature card in a slot with a new feature card of the same type, the system software recognizes the new feature card and brings up the trunk interfaces automatically. If you replace the existing feature card with a new feature card of a different type, you must reconfigure the system. For configuration details, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide.
To install the voice feature card, follow these steps:
Step 1 Attach an
Step 2 Slide the feature card into the slot until the connector pins make contact with the carrier card backplane connector. (See Figure
Figure 6-9 Installing a Feature Card in the Cisco AS5350XM Universal Gateway
36820
Figure 6-10 Installing a Feature Card in the Cisco AS5400XM Universal Gateway
| 37201 |
Step 3 | Align the captive screws with their holes, and then seat the card completely. |
Step 4 | Seat the feature card in the carrier by pushing the card firmly until the captive screws are aligned with |
| their holes. |
Step 5 Tighten the screws to secure the feature card to the chassis. (See Figure
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
|
|
| |
|
|